From: Fabio Estevam <festevam@xxxxxxx>
According to leds-gpio.yaml, the LED nodes should not contain
unit addresses. Remove them.
Also, 'default-trigger' is not a valid property. Change it to
'linux,default-trigger'.
These changes fix the following dt-schema warnings:
led@1: Unevaluated properties are not allowed ('reg' was unexpected)
led@2: Unevaluated properties are not allowed ('reg' was unexpected)
led@3: Unevaluated properties are not allowed ('default-trigger', 'reg' were unexpected)
leds: '#address-cells', '#size-cells' do not match any of the regexes: '(^led-[0-9a-f]$|led)', 'pinctrl-[0-9]+'
Signed-off-by: Fabio Estevam <festevam@xxxxxxx>
---
arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts | 13 ++++---------
1 file changed, 4 insertions(+), 9 deletions(-)
diff --git a/arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts b/arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts
index 0f01dded4e3d..ca62e7933116 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts
+++ b/arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts
@@ -24,30 +24,25 @@ reg_usb0_vbus: regulator-0 {
};
leds {
- #address-cells = <1>;
- #size-cells = <0>;
compatible = "gpio-leds";
status = "okay";
- led@1 {
+ led-1 {
label = "sps1-1:yellow:user";
gpios = <&gpio0 6 0>;
linux,default-trigger = "heartbeat";
- reg = <0>;
};
- led@2 {
+ led-2 {
label = "sps1-2:red:user";
gpios = <&gpio0 3 0>;
linux,default-trigger = "heartbeat";
- reg = <1>;
};
- led@3 {
+ led-3 {
label = "sps1-3:red:user";
gpios = <&gpio0 0 0>;
- default-trigger = "heartbeat";
- reg = <2>;
+ linux,default-trigger = "heartbeat";
};
};
--
2.34.1
