On Mon, 20 Apr 2015 11:50:56 +0200 Paul Bolle <pebolle@xxxxxxxxxx> wrote: > On Sat, 2015-04-18 at 18:31 +0200, Alban wrote: > > On Sat, 18 Apr 2015 09:05:52 +0200 > > Paul Bolle <pebolle@xxxxxxxxxx> wrote: > > > > > On Fri, 2015-04-17 at 16:24 +0200, Alban Bedel wrote: > > > > > > > --- a/arch/mips/ath79/Kconfig > > > > +++ b/arch/mips/ath79/Kconfig > > > > > > > > +choice > > > > + prompt "Builtin devicetree selection" > > > > + default DTB_ATH79_NONE > > > > + help > > > > + Select the devicetree. > > > > + > > > > + config DTB_ATH79_NONE > > > > + bool "None" > > > > +endchoice > > > > > > This adds a choice block with one config entry. So what this > > > achieves is that DTB_ATH79_NONE will always be 'y', right? > > > Besides I didn't notice on a user of CONFIG_DTB_ATH79_NONE. So as > > > far as I can see this choice has no effect on the build. > > > > > > Why was this choice entry added? > > > > This menu is for boards that need a built-in DTB, as MIPS currently > > doesn't support appended DTBs it is the only way to load a DTB on > > boards stuck with a broken boot loader. But as no board has been > > added yet it only contain the entry for boards that don't need a > > built-in DTB, which do nothing as you pointed out. > > > > A board is then added in this menu in patch 14, for some reasons git > > send-email didn't send the whole serie at once :( > > I saw 14/14 fly by now. (And I saw 12/12 of v2, which basically > replaces 14/14.) That makes things clear. > > Perhaps, if you're going to send a v3, you might move this change into > 12/12. At least, I see little reason to add this choice block in two > separate steps in this series. Ok, I'll do that. > (Side note: you _might_ be able to drop config DTB_ATH79_NONE entirely > if you also replace > default DTB_ATH79_NONE > > with > optional > > optional is a little used option for choice blocks. I haven't tested > this, so this suggestion could end up wasting your time. And even then > this all looks like a complicated way to set just DTB_TL_WR1043ND_V1. I'll try that. > I suppose you expect to add things to this choice block in the > future.) This is the only ATH79 board I currently have access to. However openwrt has patches to add support for quiet a few, so I hope more boards will be submitted once we have DT support in. Most of these boards are appliance stuck with old bootloaders, so they will need this too. Alban -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
