On Wed, Jan 15, 2025 at 09:33:35AM +0000, Wenbin Mei (梅文彬) wrote:
> On Wed, 2025-01-15 at 08:29 +0100, Christian Marangi wrote:
> > External email : Please do not click links or open attachments until
> > you have verified the sender or the content.
> >
> >
> > Add support for AN7581 MMC Host. The MMC Host controller is based on
> > mt7622 with the difference of not having regulator supply and
> > state_uhs
> > pins and hclk clock.
> >
> > Some minor fixes are applied to check if the state_uhs pins are
> > defined
> > and make hclk optional for the new airoha compatible.
> >
> > Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx>
> > ---
> > drivers/mmc/host/mtk-sd.c | 55 ++++++++++++++++++++++++++++++++-----
> > --
> > 1 file changed, 46 insertions(+), 9 deletions(-)
> >
> > diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
> > index efb0d2d5716b..9d6868883c91 100644
> > --- a/drivers/mmc/host/mtk-sd.c
> > +++ b/drivers/mmc/host/mtk-sd.c
> > @@ -666,6 +666,20 @@ static const struct mtk_mmc_compatible
> > mt8196_compat = {
> > .support_new_rx = true,
> > };
> >
> > +static const struct mtk_mmc_compatible an7581_compat = {
> > + .clk_div_bits = 12,
> > + .recheck_sdio_irq = true,
> > + .hs400_tune = false,
> > + .pad_tune_reg = MSDC_PAD_TUNE0,
> > + .async_fifo = true,
> > + .data_tune = true,
> > + .busy_check = true,
> > + .stop_clk_fix = true,
> > + .stop_dly_sel = 3,
> > + .enhance_rx = true,
> > + .support_64g = false,
> > +};
> > +
> > static const struct of_device_id msdc_of_ids[] = {
> > { .compatible = "mediatek,mt2701-mmc", .data =
> > &mt2701_compat},
> > { .compatible = "mediatek,mt2712-mmc", .data =
> > &mt2712_compat},
> > @@ -680,7 +694,7 @@ static const struct of_device_id msdc_of_ids[] =
> > {
> > { .compatible = "mediatek,mt8183-mmc", .data =
> > &mt8183_compat},
> > { .compatible = "mediatek,mt8196-mmc", .data =
> > &mt8196_compat},
> > { .compatible = "mediatek,mt8516-mmc", .data =
> > &mt8516_compat},
> > -
> > + { .compatible = "airoha,an7581-mmc", .data = &an7581_compat},
> > {}
> > };
> > MODULE_DEVICE_TABLE(of, msdc_of_ids);
> > @@ -1600,6 +1614,10 @@ static int msdc_ops_switch_volt(struct
> > mmc_host *mmc, struct mmc_ios *ios)
> > struct msdc_host *host = mmc_priv(mmc);
> > int ret;
> >
> > + /* Skip setting supply if not supported */
> > + if (!mmc->supply.vqmmc)
> > + return 0;
> > +
> > if (!IS_ERR(mmc->supply.vqmmc)) {
> > if (ios->signal_voltage != MMC_SIGNAL_VOLTAGE_330 &&
> > ios->signal_voltage != MMC_SIGNAL_VOLTAGE_180) {
> > @@ -1699,7 +1717,9 @@ static void msdc_enable_sdio_irq(struct
> > mmc_host *mmc, int enb)
> > dev_dbg(host->dev, "SDIO eint irq:
> > %d!\n", host->eint_irq);
> > }
> >
> > - pinctrl_select_state(host->pinctrl, host-
> > >pins_uhs);
> > + /* Skip setting uhs pins if not supported */
> > + if (host->pins_uhs)
> > + pinctrl_select_state(host->pinctrl,
> > host->pins_uhs);
> > } else {
> > dev_pm_clear_wake_irq(host->dev);
> > }
> > @@ -2036,6 +2056,10 @@ static void msdc_ops_set_ios(struct mmc_host
> > *mmc, struct mmc_ios *ios)
> >
> > msdc_set_buswidth(host, ios->bus_width);
> >
> > + /* Skip regulator if not supported */
> > + if (!mmc->supply.vmmc)
> > + goto skip_regulator;
> > +
> If power_mode is MMC_POWER_UP, we need to execute the related flow.
> Now it will skip mmc_init_hw(host), which will cause problems.
> BTW, can this be implemented using a fix regulator? if ok, no need
> to modify here.
Yes I didn't think of that, I will test if this is possible and reply
back, thanks for the hint.
> > /* Suspend/Resume will do power off/on */
> > switch (ios->power_mode) {
> > case MMC_POWER_UP:
> > @@ -2071,6 +2095,7 @@ static void msdc_ops_set_ios(struct mmc_host
> > *mmc, struct mmc_ios *ios)
> > break;
> > }
> >
> > +skip_regulator:
> > if (host->mclk != ios->clock || host->timing != ios->timing)
> > msdc_set_mclk(host, ios->timing, ios->clock);
> > }
> > @@ -2816,9 +2841,12 @@ static int msdc_of_clock_parse(struct
> > platform_device *pdev,
> > if (IS_ERR(host->src_clk))
> > return PTR_ERR(host->src_clk);
> >
> > - host->h_clk = devm_clk_get(&pdev->dev, "hclk");
> > - if (IS_ERR(host->h_clk))
> > - return PTR_ERR(host->h_clk);
> > + /* AN7581 SoC doesn't have hclk */
> > + if (!device_is_compatible(&pdev->dev, "airoha,an7581-mmc")) {
> > + host->h_clk = devm_clk_get(&pdev->dev, "hclk");
> > + if (IS_ERR(host->h_clk))
> > + return PTR_ERR(host->h_clk);
> > + }
> >
> > host->bus_clk = devm_clk_get_optional(&pdev->dev, "bus_clk");
> > if (IS_ERR(host->bus_clk))
> > @@ -2926,10 +2954,13 @@ static int msdc_drv_probe(struct
> > platform_device *pdev)
> > return PTR_ERR(host->pins_default);
> > }
> >
> > - host->pins_uhs = pinctrl_lookup_state(host->pinctrl,
> > "state_uhs");
> > - if (IS_ERR(host->pins_uhs)) {
> > - dev_err(&pdev->dev, "Cannot find pinctrl uhs!\n");
> > - return PTR_ERR(host->pins_uhs);
> > + /* AN7581 doesn't have state_uhs pins */
> > + if (!device_is_compatible(&pdev->dev, "airoha,an7581-mmc")) {
> > + host->pins_uhs = pinctrl_lookup_state(host->pinctrl,
> > "state_uhs");
> > + if (IS_ERR(host->pins_uhs)) {
> > + dev_err(&pdev->dev, "Cannot find pinctrl
> > uhs!\n");
> > + return PTR_ERR(host->pins_uhs);
> > + }
> > }
> >
> > /* Support for SDIO eint irq ? */
> > @@ -3010,6 +3041,12 @@ static int msdc_drv_probe(struct
> > platform_device *pdev)
> > dev_err(&pdev->dev, "Cannot ungate clocks!\n");
> > goto release_clk;
> > }
> > +
> > + /* AN7581 without regulator require tune to OCR values */
> > + if (device_is_compatible(&pdev->dev, "airoha,an7581-mmc") &&
> > + !mmc->ocr_avail)
> > + mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
> > +
> > msdc_init_hw(host);
> >
> > if (mmc->caps2 & MMC_CAP2_CQE) {
> > --
> > 2.45.2
> >
--
Ansuel
