Hi, Angelo:
On Thu, 2024-12-05 at 12:45 +0100, AngeloGioacchino Del Regno wrote:
> External email : Please do not click links or open attachments until you have verified the sender or the content.
>
>
> Add support for the newer HDMI-TX (Encoder) v2 and DDC v2 IPs
> found in MediaTek's MT8195, MT8188 SoC and their variants, and
> including support for display modes up to 4k60 and for HDMI
> Audio, as per the HDMI 2.0 spec.
>
> HDCP and CEC functionalities are also supported by this hardware,
> but are not included in this commit and that also poses a slight
> difference between the V2 and V1 controllers in how they handle
> Hotplug Detection (HPD).
>
> While the v1 controller was using the CEC controller to check
> HDMI cable connection and disconnection, in this driver the v2
> one does not.
>
> This is due to the fact that on parts with v2 designs, like the
> MT8195 SoC, there is one CEC controller shared between the HDMI
> Transmitter (HDMI-TX) and Receiver (HDMI-RX): before eventually
> adding support to use the CEC HW to wake up the HDMI controllers
> it is necessary to have support for one TX, one RX *and* for both
> at the same time.
>
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
> ---
[snip]
> +static void mtk_hdmi_v2_bridge_enable(struct drm_bridge *bridge,
> + struct drm_bridge_state *old_state)
> +{
> + struct mtk_hdmi *hdmi = hdmi_ctx_from_bridge(bridge);
> + struct drm_atomic_state *state = old_state->base.state;
> + int ret;
> +
> + ret = drm_atomic_helper_connector_hdmi_update_infoframes(hdmi->curr_conn, state);
> + if (ret)
> + dev_err(hdmi->dev, "Could not update infoframes: %d\n", ret);
> +
> + mtk_hdmi_v2_hw_vid_mute(hdmi, false);
> + mtk_hdmi_v2_hw_aud_mute(hdmi, false);
In v1, it does not unmute when bridge enable.
I would like v1 and v2 has the same behavior.
If possible, remove these code.
If remove thee code would result in some problem,
add comment to describe why need these code.
Regards,
CK
> +
> + /* signal the connect event to audio codec */
> + mtk_hdmi_v2_handle_plugged_change(hdmi, true);
> +
> + hdmi->enabled = true;
> +}
> +
