On 12/8/2024 5:35 PM, Dmitry Baryshkov wrote:
On Fri, Dec 06, 2024 at 08:15:35PM +0530, Janaki Ramaiah Thota wrote:
On 12/5/2024 4:29 AM, Dmitry Baryshkov wrote:
On Wed, Dec 04, 2024 at 06:47:04PM +0530, Janaki Ramaiah Thota wrote:
Add a node for the PMU module of the WCN6750 present on the
qcs6490-rb3gen board and assign its power outputs to the Bluetooth
module.
Signed-off-by: Janaki Ramaiah Thota <quic_janathot@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 165 ++++++++++++++++++-
1 file changed, 164 insertions(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
index 27695bd54220..07650648214e 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
@@ -1,6 +1,6 @@
// SPDX-License-Identifier: BSD-3-Clause
/*
- * Copyright (c) 2023 Qualcomm Innovation Center, Inc. All rights reserved.
+ * Copyright (c) 2023-2024 Qualcomm Innovation Center, Inc. All rights reserved.
*/
/dts-v1/;
@@ -33,6 +33,7 @@
aliases {
serial0 = &uart5;
+ serial1 = &uart7;
};
chosen {
@@ -217,6 +218,63 @@
regulator-min-microvolt = <3700000>;
regulator-max-microvolt = <3700000>;
};
+
+ wcn6750-pmu {
+ compatible = "qcom,wcn6750-pmu";
+ pinctrl-names = "default";
+ pinctrl-0 = <&bt_en>;
+ vddaon-supply = <&vreg_s7b_0p972>;
+ vddasd-supply = <&vreg_l11c_2p8>;
+ vddpmu-supply = <&vreg_s7b_0p972>;
+ vddrfa0p8-supply = <&vreg_s7b_0p972>;
+ vddrfa1p2-supply = <&vreg_s8b_1p272>;
+ vddrfa1p7-supply = <&vreg_s1b_1p872>;
+ vddrfa2p2-supply = <&vreg_s1c_2p19>;
+
+ bt-enable-gpios = <&tlmm 85 GPIO_ACTIVE_HIGH>;
Doesn't WCN6750 also have SW_CTRL and wifi-enable pins?
For Bluetooth, these pins are not needed. We have verified Bluetooth
functionality, and it is working fine.
You are describing the hardware (PMU), not "a part of the PMU for the
BT". Please check if there should be a wifi enable pin and adjust
accordingly.
We further checked with WiFi team. For wcn6750, sw_ctrl and wifi-enable
pins handled from WiFi firmware/controller. So it is not needed to
handle in PMU.
Thanks,
Janakiram
