Re: [PATCH v2 03/18] arm64: dts: mediatek: mt7988: add fixed regulators for 1v8 and 3v3

[AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>]

Il 02/12/24 13:25, Frank Wunderlich ha scritto:
> From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
>
> Add regulator nodes used for mmc to Bananapi R4 board.
>
> Signed-off-by: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>

If you're adding the eMMC regulators, I assume that there's an eMMC, or that even
if there's no device in some version of the board, these two regulators are always
assigned to the eMMC device - right?

You should, at this point, do exactly that: you can leave the mmc0 disabled and
only enable it in a DTBO.

&mmc0 {
	/* eMMC gets enabled by DTBO if present */
	vmmc-supply = <&reg_3p3v>;
	vqmmc-supply = <&reg_1p8v>;
};

Cheers,
Angelo

> ---
> v2:
> - move mmc regulators to board dts of bpi-r4
> ---
>   .../dts/mediatek/mt7988a-bananapi-bpi-r4.dts   | 18 ++++++++++++++++++
>   1 file changed, 18 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/mediatek/mt7988a-bananapi-bpi-r4.dts b/arch/arm64/boot/dts/mediatek/mt7988a-bananapi-bpi-r4.dts
> index d914eae2b524..df53512c6890 100644
> --- a/arch/arm64/boot/dts/mediatek/mt7988a-bananapi-bpi-r4.dts
> +++ b/arch/arm64/boot/dts/mediatek/mt7988a-bananapi-bpi-r4.dts
> @@ -8,6 +8,24 @@ / {
>   	compatible = "bananapi,bpi-r4", "mediatek,mt7988a";
>   	model = "Banana Pi BPI-R4";
>   	chassis-type = "embedded";
> +
> +	reg_1p8v: regulator-1p8v {
> +		compatible = "regulator-fixed";
> +		regulator-name = "fixed-1.8V";
> +		regulator-min-microvolt = <1800000>;
> +		regulator-max-microvolt = <1800000>;
> +		regulator-boot-on;
> +		regulator-always-on;
> +	};
> +
> +	reg_3p3v: regulator-3p3v {
> +		compatible = "regulator-fixed";
> +		regulator-name = "fixed-3.3V";
> +		regulator-min-microvolt = <3300000>;
> +		regulator-max-microvolt = <3300000>;
> +		regulator-boot-on;
> +		regulator-always-on;
> +	};
>   };
>   
>   &pio {