On Tue, Nov 26, 2024 at 11:32:59PM +0530, Krishna Kurapati wrote:
>
>
> On 11/2/2024 8:33 AM, Dmitry Baryshkov wrote:
> > Add DT file for the Qualcomm SAR2130P platform.
> >
> > Co-developed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
> > Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
> > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> > ---
> > arch/arm64/boot/dts/qcom/sar2130p.dtsi | 3123 ++++++++++++++++++++++++++++++++
> > 1 file changed, 3123 insertions(+)
> >
>
> [...]
>
> > + usb_dp_qmpphy: phy@88e8000 {
> > + compatible = "qcom,sar2130p-qmp-usb3-dp-phy";
> > + reg = <0x0 0x088e8000 0x0 0x3000>;
> > +
> > + clocks = <&gcc GCC_USB3_PRIM_PHY_AUX_CLK>,
> > + <&rpmhcc RPMH_CXO_CLK>,
> > + <&gcc GCC_USB3_PRIM_PHY_COM_AUX_CLK>,
> > + <&gcc GCC_USB3_PRIM_PHY_PIPE_CLK>;
> > + clock-names = "aux", "ref", "com_aux", "usb3_pipe";
> > +
> > + power-domains = <&gcc USB3_PHY_GDSC>;
> > +
> > + resets = <&gcc GCC_USB3_PHY_PRIM_BCR>,
> > + <&gcc GCC_USB3_DP_PHY_PRIM_BCR>;
> > + reset-names = "phy", "common";
> > +
> > + #clock-cells = <1>;
> > + #phy-cells = <1>;
> > +
> > + orientation-switch;
> > +
> > + status = "disabled";
> > +
>
> Hi Dmitry,
>
> Sorry for asking this question after code got merged. I forgot about asking
> this last time when I commented on your patch and provided the HS Phy IRQ
> value.
>
> In SAR2130P, I remember that the lane orientation is reversed. As in on
> normal targets, if the orientatin GPIO reads "0" it means LANE_A but on
> SAR2130 it means LANE_B. Can you confirm if superspeed was tested only in
> one orientation only.
Thanks for the notice. I don't remember if I had USB3 or just USB2
connected to the USB-C connector. I will take a look and report
afterwards, but it might take some time.
>
> I can push code for setting orienation properly for this target if you can
> confirm that orienation is read reverse on SAR2130P.
>
> Regards,
> Krishna,
--
With best wishes
Dmitry
