The integrated usb phys are supplied by the 3p0 regulator, which has a voltage range of 2.625V to 3.4V. Thus the min and max values are corrected and the regulator added as a proper supply for the usb phys. This fixes the following warnings during the probe of the mxs_phy driver: mxs_phy 20c9000.usbphy: supply phy-3p0 not found, using dummy regulator mxs_phy 20ca000.usbphy: supply phy-3p0 not found, using dummy regulator The regulator handling was introduced by commit `966d73152078 (usb: phy: mxs: enable regulator phy-3p0 to improve signal qualilty, 2024-07-26)`. Signed-off-by: Stefan Kerkmann <s.kerkmann@xxxxxxxxxxxxxx> --- arch/arm/boot/dts/nxp/imx/imx6sx.dtsi | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi b/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi index a9550f115f82699336f62c33214c9a9bb04e79e0..5132b575b001564b9767605ae7ff044701516673 100644 --- a/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi +++ b/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi @@ -637,8 +637,8 @@ reg_vdd1p1: regulator-1p1 { reg_vdd3p0: regulator-3p0 { compatible = "fsl,anatop-regulator"; regulator-name = "vdd3p0"; - regulator-min-microvolt = <2800000>; - regulator-max-microvolt = <3150000>; + regulator-min-microvolt = <2625000>; + regulator-max-microvolt = <3400000>; regulator-always-on; anatop-reg-offset = <0x120>; anatop-vol-bit-shift = <8>; @@ -731,6 +731,7 @@ usbphy1: usbphy@20c9000 { reg = <0x020c9000 0x1000>; interrupts = <GIC_SPI 44 IRQ_TYPE_LEVEL_HIGH>; clocks = <&clks IMX6SX_CLK_USBPHY1>; + phy-3p0-supply = <®_vdd3p0>; fsl,anatop = <&anatop>; }; @@ -739,6 +740,7 @@ usbphy2: usbphy@20ca000 { reg = <0x020ca000 0x1000>; interrupts = <GIC_SPI 45 IRQ_TYPE_LEVEL_HIGH>; clocks = <&clks IMX6SX_CLK_USBPHY2>; + phy-3p0-supply = <®_vdd3p0>; fsl,anatop = <&anatop>; }; -- 2.39.5