On 11/7/24 5:10 PM, Marek Vasut wrote:
On 11/7/24 2:28 AM, Ajay.Kathat@xxxxxxxxxxxxx wrote:
Hi Marek,
Hello Ajay,
On 11/4/24 04:44, Marek Vasut wrote:
EXTERNAL EMAIL: Do not click links or open attachments unless you
know the
content is safe
On 10/23/24 8:47 PM, Marek Vasut wrote:
Hello again,
Is power-save enabled during the test. With PS enabled, The SDIO
commands may
fail momentarily but it should recover.
It seems it gets enabled after first ifconfig up, that's a good hint,
I'll try to disable it and see if that makes them errors go away.
Thanks!
Do you have any details on WHY would such sporadic errors occur and how
to make those go away even with PS enabled ?
Can you explain why does uAPSD (iw ...set power_save off) adversely
affect SDIO bus stability ?
SDIO bus errors can occur for different reasons and those errors can
be of
recoverable or non-recoverable type. For non-recoverable failures like
firmware crashes, the retry mechanism may not help to resolve the
issue. If
the error is recoverable then driver should work with retry attempts.
I think you are observing the bus errors messages and it is recovering
after
that. Is my understanding correct?
I don't know. Is there any way to make the WILC firmware produce debug
output , so we can figure out what is going on "on the other side" ?
Are you able to provide me (maybe off-list) some debug firmware build ?
(or can I get firmware sources and build and debug my own WILC firmware
on the Cortus CPU?)
With the previous shared test procedure, which makes the interface up/
down
continuously, the station may not go into the Doze/Awake sequence
since that
mode switching gets activated after connection with AP.
What does this mean ? I can trigger the SDIO errors even without being
connected to any AP , so this is something between the WILC and the SDIO
host, the radio is likely not involved , right ?
Can you explain how to prevent that or shall we disable uAPSD
altogether ?
Could you please share the test procedure and logs. I am occupied at the
moment but I shall make some time to look into it and get a better
understanding.
The simplest test procedure is this:
$ while true ; do ifconfig wlan0 up ; ifconfig wlan0 down ; done
As for the logs, MMCI controller sporadically reports either Command or
Data CRC error, so likely the SDIO response (from WILC to Host) is
corrupted.
Are there any news ?
