On Fri, Nov 01, 2024 at 03:06:08PM +0800, Richard Zhu wrote:
> From: Frank Li <Frank.Li@xxxxxxx>
>
> Call common dwc suspend/resume function. Use dwc common iATU method to
> send out PME_TURN_OFF message. In Old DWC implementations,
> PCIE_ATU_INHIBIT_PAYLOAD bit in iATU Ctrl2 register is reserved. So the
> generic DWC implementation of sending the PME_Turn_Off message using a
> dummy MMIO write cannot be used. Use previouse method to kick off
> PME_TURN_OFF MSG for these platforms.
>
> Replace the imx_pcie_stop_link() and imx_pcie_host_exit() by
> dw_pcie_suspend_noirq() in imx_pcie_suspend_noirq().
>
> Since dw_pcie_suspend_noirq() already does these, see below call stack:
> dw_pcie_suspend_noirq()
> dw_pcie_stop_link();
> imx_pcie_stop_link();
> pci->pp.ops->deinit();
> imx_pcie_host_exit();
>
> Replace the imx_pcie_host_init(), dw_pcie_setup_rc() and
> imx_pcie_start_link() by dw_pcie_resume_noirq() in
> imx_pcie_resume_noirq().
>
> Since dw_pcie_resume_noirq() already does these, see below call stack:
> dw_pcie_resume_noirq()
> pci->pp.ops->init();
> imx_pcie_host_init();
> dw_pcie_setup_rc();
> dw_pcie_start_link();
> imx_pcie_start_link();
>
Are these two changes (dw_pcie_suspend_noirq(), dw_pcie_resume_noirq()) related
to this patch? If not, these should be in a separate patch.
> Signed-off-by: Frank Li <Frank.Li@xxxxxxx>
> Signed-off-by: Richard Zhu <hongxing.zhu@xxxxxxx>
> ---
> drivers/pci/controller/dwc/pci-imx6.c | 95 ++++++++++-----------------
> 1 file changed, 34 insertions(+), 61 deletions(-)
>
> diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
> index fde2f4eaf804..3c074cc2605f 100644
> --- a/drivers/pci/controller/dwc/pci-imx6.c
> +++ b/drivers/pci/controller/dwc/pci-imx6.c
> @@ -33,6 +33,7 @@
> #include <linux/pm_domain.h>
> #include <linux/pm_runtime.h>
>
> +#include "../../pci.h"
> #include "pcie-designware.h"
>
> #define IMX8MQ_GPR_PCIE_REF_USE_PAD BIT(9)
> @@ -108,19 +109,18 @@ struct imx_pcie_drvdata {
> int (*init_phy)(struct imx_pcie *pcie);
> int (*enable_ref_clk)(struct imx_pcie *pcie, bool enable);
> int (*core_reset)(struct imx_pcie *pcie, bool assert);
> + const struct dw_pcie_host_ops *ops;
> };
>
> struct imx_pcie {
> struct dw_pcie *pci;
> struct gpio_desc *reset_gpiod;
> - bool link_is_up;
> struct clk_bulk_data clks[IMX_PCIE_MAX_CLKS];
> struct regmap *iomuxc_gpr;
> u16 msi_ctrl;
> u32 controller_id;
> struct reset_control *pciephy_reset;
> struct reset_control *apps_reset;
> - struct reset_control *turnoff_reset;
> u32 tx_deemph_gen1;
> u32 tx_deemph_gen2_3p5db;
> u32 tx_deemph_gen2_6db;
> @@ -899,13 +899,11 @@ static int imx_pcie_start_link(struct dw_pcie *pci)
> dev_info(dev, "Link: Only Gen1 is enabled\n");
> }
>
> - imx_pcie->link_is_up = true;
> tmp = dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKSTA);
> dev_info(dev, "Link up, Gen%i\n", tmp & PCI_EXP_LNKSTA_CLS);
> return 0;
>
> err_reset_phy:
> - imx_pcie->link_is_up = false;
> dev_dbg(dev, "PHY DEBUG_R0=0x%08x DEBUG_R1=0x%08x\n",
> dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG0),
> dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG1));
> @@ -1024,9 +1022,32 @@ static u64 imx_pcie_cpu_addr_fixup(struct dw_pcie *pcie, u64 cpu_addr)
> return cpu_addr - entry->offset;
> }
>
> +/*
> + * In Old DWC implementations, PCIE_ATU_INHIBIT_PAYLOAD bit in iATU Ctrl2
> + * register is reserved. So the generic DWC implementation of sending the
> + * PME_Turn_Off message using a dummy MMIO write cannot be used.
> + */
> +static void imx_pcie_pme_turn_off(struct dw_pcie_rp *pp)
> +{
> + struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
> + struct imx_pcie *imx_pcie = to_imx_pcie(pci);
> +
> + regmap_set_bits(imx_pcie->iomuxc_gpr, IOMUXC_GPR12, IMX6SX_GPR12_PCIE_PM_TURN_OFF);
> + regmap_clear_bits(imx_pcie->iomuxc_gpr, IOMUXC_GPR12, IMX6SX_GPR12_PCIE_PM_TURN_OFF);
> +
> + usleep_range(PCIE_PME_TO_L2_TIMEOUT_US/10, PCIE_PME_TO_L2_TIMEOUT_US);
> +}
> +
> +
Stray newline.
> static const struct dw_pcie_host_ops imx_pcie_host_ops = {
> .init = imx_pcie_host_init,
> .deinit = imx_pcie_host_exit,
> + .pme_turn_off = imx_pcie_pme_turn_off,
> +};
> +
> +static const struct dw_pcie_host_ops imx_pcie_host_dw_pme_ops = {
> + .init = imx_pcie_host_init,
> + .deinit = imx_pcie_host_exit,
> };
>
> static const struct dw_pcie_ops dw_pcie_ops = {
> @@ -1147,43 +1168,6 @@ static int imx_add_pcie_ep(struct imx_pcie *imx_pcie,
> return 0;
> }
>
> -static void imx_pcie_pm_turnoff(struct imx_pcie *imx_pcie)
> -{
> - struct device *dev = imx_pcie->pci->dev;
> -
> - /* Some variants have a turnoff reset in DT */
> - if (imx_pcie->turnoff_reset) {
> - reset_control_assert(imx_pcie->turnoff_reset);
> - reset_control_deassert(imx_pcie->turnoff_reset);
Where these are handled in imx_pcie_pme_turn_off()? If you removed them
intentionally for a reason, it should be mentioned in commit message.
> - goto pm_turnoff_sleep;
> - }
> -
> - /* Others poke directly at IOMUXC registers */
> - switch (imx_pcie->drvdata->variant) {
> - case IMX6SX:
> - case IMX6QP:
> - regmap_update_bits(imx_pcie->iomuxc_gpr, IOMUXC_GPR12,
> - IMX6SX_GPR12_PCIE_PM_TURN_OFF,
> - IMX6SX_GPR12_PCIE_PM_TURN_OFF);
> - regmap_update_bits(imx_pcie->iomuxc_gpr, IOMUXC_GPR12,
> - IMX6SX_GPR12_PCIE_PM_TURN_OFF, 0);
> - break;
> - default:
> - dev_err(dev, "PME_Turn_Off not implemented\n");
> - return;
> - }
> -
> - /*
> - * Components with an upstream port must respond to
> - * PME_Turn_Off with PME_TO_Ack but we can't check.
> - *
> - * The standard recommends a 1-10ms timeout after which to
> - * proceed anyway as if acks were received.
> - */
> -pm_turnoff_sleep:
> - usleep_range(1000, 10000);
> -}
> -
> static void imx_pcie_msi_save_restore(struct imx_pcie *imx_pcie, bool save)
> {
> u8 offset;
> @@ -1207,36 +1191,26 @@ static void imx_pcie_msi_save_restore(struct imx_pcie *imx_pcie, bool save)
[...]
> @@ -1267,11 +1241,14 @@ static int imx_pcie_probe(struct platform_device *pdev)
>
> pci->dev = dev;
> pci->ops = &dw_pcie_ops;
> - pci->pp.ops = &imx_pcie_host_ops;
>
> imx_pcie->pci = pci;
> imx_pcie->drvdata = of_device_get_match_data(dev);
>
> + pci->pp.ops = &imx_pcie_host_dw_pme_ops;
> + if (imx_pcie->drvdata->ops)
> + pci->pp.ops = imx_pcie->drvdata->ops;
Use if..else pattern
> +
> /* Find the PHY if one is defined, only imx7d uses it */
> np = of_parse_phandle(node, "fsl,imx7d-pcie-phy", 0);
> if (np) {
> @@ -1343,13 +1320,6 @@ static int imx_pcie_probe(struct platform_device *pdev)
> break;
> }
>
> - /* Grab turnoff reset */
> - imx_pcie->turnoff_reset = devm_reset_control_get_optional_exclusive(dev, "turnoff");
> - if (IS_ERR(imx_pcie->turnoff_reset)) {
> - dev_err(dev, "Failed to get TURNOFF reset control\n");
> - return PTR_ERR(imx_pcie->turnoff_reset);
> - }
> -
Same here. Reason not explained.
- Mani
--
மணிவண்ணன் சதாசிவம்
