On Wed, Nov 06, 2024 at 01:22:38PM +0100, Christian Marangi wrote:
> +/* MII Registers Page 1 */
> +#define AN8855_PHY_EXT_REG_14 0x14
> +#define AN8855_PHY_EN_DOWN_SHFIT BIT(4)
Shouldn't "AN8855_PHY_EN_DOWN_SHFIT" be "AN8855_PHY_EN_DOWN_SHIFT"
(notice the I and F are swapped) ?
> +static int an8855_get_downshift(struct phy_device *phydev, u8 *data)
> +{
> + int saved_page;
> + int val;
> + int ret;
> +
> + saved_page = phy_select_page(phydev, AN8855_PHY_PAGE_EXTENDED_1);
> + if (saved_page >= 0)
> + val = __phy_read(phydev, AN8855_PHY_EXT_REG_14);
> + ret = phy_restore_page(phydev, saved_page, val);
> + if (ret)
> + return ret;
This function is entirely broken.
phy_restore_page() will return "val" if everything went successfully,
so here you end up returning "val" via this very return statement
without executing any further code in the function. The only time
further code will be executed is if "val" was successfully read as
zero.
Please use the helpers provided:
ret = phy_read_paged(phydev, AN8855_PHY_PAGE_EXTENDED_1,
AN8855_PHY_EXT_REG_14);
if (ret < 0)
return ret;
ret now contains what you're using as "val" below. No need to open code
phy_read_paged().
> +
> + *data = val & AN8855_PHY_EXT_REG_14 ? DOWNSHIFT_DEV_DEFAULT_COUNT :
> + DOWNSHIFT_DEV_DISABLE;
Here, the test is against the register number rather than the bit that
controls downshift. Shouldn't AN8855_PHY_EXT_REG_14 be
AN8855_PHY_EN_DOWN_SH(F)I(F)T ?
> +static int an8855_set_downshift(struct phy_device *phydev, u8 cnt)
> +{
> + int saved_page;
> + int ret;
> +
> + saved_page = phy_select_page(phydev, AN8855_PHY_PAGE_EXTENDED_1);
> + if (saved_page >= 0) {
> + if (cnt != DOWNSHIFT_DEV_DISABLE)
> + ret = __phy_set_bits(phydev, AN8855_PHY_EXT_REG_14,
> + AN8855_PHY_EN_DOWN_SHFIT);
> + else
> + ret = __phy_clear_bits(phydev, AN8855_PHY_EXT_REG_14,
> + AN8855_PHY_EN_DOWN_SHFIT);
> + }
> +
> + return phy_restore_page(phydev, saved_page, ret);
This entire thing can be simplified to:
u16 ds = cnt != DOWNSHIFT_DEV_DISABLE ? AN8855_PHY_EN_DOWN_SHFIT: 0;
return phy_modify_paged(phydev, AN8855_PHY_PAGE_EXTENDED_1,
AN8855_PHY_EXT_REG_14, AN8855_PHY_EN_DOWN_SHFIT,
ds);
Thanks.
--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!
