Hi Lukasz,
Am 06.11.24 um 11:57 schrieb Lukasz Majewski:
On Thu, 31 Oct 2024 09:42:36 +0100
Lukasz Majewski <lukma@xxxxxxx> wrote:
Dear Community,
The btt3 device' HW revisions from 0 to 2 use imx287 SoC and are to
some extend similar to already upstreamed XEA devices, hence are
using common imx28-lwe.dtsi file.
New, imx28-btt3.dtsi has been added to embrace common DTS
properties for different HW revisions for this device.
As a result - changes introduced in imx28-btt3-[012].dts are
minimal.
Signed-off-by: Lukasz Majewski <lukma@xxxxxxx>
---
Changes for v2:
- Rename dts file from btt3-[012] to imx28-btt3-[012] to match
current linux kernel naming convention
- Remove 'wlf,wm8974' from compatible for codec@1a
Changes for v3:
- Keep alphabethical order for Makefile entries
Changes for v4:
- Change compatible for btt3 board (to 'lwn,imx28-btt3')
Changes for v5:
- Combine patch, which adds btt3-[012] with one adding board entry
to fsl.yaml
Changes for v6:
- Make the patch series for adding entry in fsl.yaml and btt3
Changes for v7:
- Use "panel" property as suggested by the community
- Use panel-timing to specify the display parameters
- Update subject line with correct tags
Changes for v8:
- Use GPIO_ACTIVE_HIGH instead of '0'
- Add the comment regarding mac address specification
- Remove superfluous comment
- Change wifi-en-pin node name
Changes for v9:
- Remove not used 'pm-ignore-notify'
- Add display names for 'panel-dpi' compatible to avoid Schema
warnings
Changes for v10:
- Drop new line with panel-timing definitions
- Add new lines with 'sound' node
- Change 'codec' to 'audio-codec'
- Change order of properties for saif1 node
Are there any more comments regarding this patch?
Gentle ping on this patch set.
I do not see a reason to ping on this series as long Rob's comment from
Oct 22th is not addressed.
Please reply to him if something is not clear.
Best regards
