The monitored-battery property is a property of the board, not the PMIC.
Move this property to the DTS of its only user, sp9860g-1h10.
While at it, disable the fuel-gauge node by default and enable it only
for its users, as it requires board-specific properties to work correctly.
Signed-off-by: Stanislav Jakubek <stano.jakubek@xxxxxxxxx>
---
Changes in V2:
- none
Note that the 'sprd,calib-resistance-micro-ohms' property isn't specified
as I do not have the board or any other source of information about it.
If the SPRD folks could chime in here, that'd be great.
arch/arm64/boot/dts/sprd/sc2731.dtsi | 4 ++--
arch/arm64/boot/dts/sprd/sp9860g-1h10.dts | 5 +++++
2 files changed, 7 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/sprd/sc2731.dtsi b/arch/arm64/boot/dts/sprd/sc2731.dtsi
index 12136e68dada..2d27427c41a2 100644
--- a/arch/arm64/boot/dts/sprd/sc2731.dtsi
+++ b/arch/arm64/boot/dts/sprd/sc2731.dtsi
@@ -94,17 +94,17 @@ pmic_adc: adc@480 {
nvmem-cells = <&adc_big_scale>, <&adc_small_scale>;
};
- fuel-gauge@a00 {
+ pmic_fgu: fuel-gauge@a00 {
compatible = "sprd,sc2731-fgu";
reg = <0xa00>;
bat-detect-gpio = <&pmic_eic 9 GPIO_ACTIVE_HIGH>;
io-channels = <&pmic_adc 3>, <&pmic_adc 6>;
io-channel-names = "bat-temp", "charge-vol";
- monitored-battery = <&bat>;
nvmem-cell-names = "fgu_calib";
nvmem-cells = <&fgu_calib>;
interrupt-parent = <&sc2731_pmic>;
interrupts = <4>;
+ status = "disabled";
};
vibrator@ec8 {
diff --git a/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts b/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
index 94af7700f3e2..b1fa817ece1e 100644
--- a/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
+++ b/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
@@ -84,6 +84,11 @@ bat: battery {
};
};
+&pmic_fgu {
+ monitored-battery = <&bat>;
+ status = "okay";
+};
+
&uart0 {
status = "okay";
};
--
2.43.0
