On 1.11.2024 6:31 AM, Alexey Klimov wrote:
> One WSA881X amplifier is connected on QRB4210 RB2 board
> hence only mono speaker is supported. This amplifier is set
> to work in analog mode only. Also add required powerdown
> pins/gpios.
>
> Cc: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
> Signed-off-by: Alexey Klimov <alexey.klimov@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 45 ++++++++++++++++++++++++
> 1 file changed, 45 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> index fc71f5930688..76b9ae1b0ebc 100644
> --- a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> +++ b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> @@ -63,6 +63,16 @@ hdmi_con: endpoint {
> };
> };
>
> + i2c0_gpio: i2c0 {
> + compatible = "i2c-gpio";
> +
> + sda-gpios = <&tlmm 4 GPIO_ACTIVE_HIGH>;
> + scl-gpios = <&tlmm 5 GPIO_ACTIVE_HIGH>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + status = "disabled";
Does it not work with &i2c1?
Konrad
