On Thu, 31 Oct 2024 at 15:30, Stanislav Jakubek <stano.jakubek@xxxxxxxxx> wrote: > > On Thu, Aug 15, 2024 at 12:13:18PM +0200, Stanislav Jakubek wrote: > > According to DT bindings, the property is called bat-detect-gpios, not > > bat-detect-gpio. Update the property as such. > > > > Signed-off-by: Stanislav Jakubek <stano.jakubek@xxxxxxxxx> > > --- > > arch/arm64/boot/dts/sprd/sc2731.dtsi | 2 +- > > 1 file changed, 1 insertion(+), 1 deletion(-) > > > > diff --git a/arch/arm64/boot/dts/sprd/sc2731.dtsi b/arch/arm64/boot/dts/sprd/sc2731.dtsi > > index 12136e68dada..c8b30c0479fd 100644 > > --- a/arch/arm64/boot/dts/sprd/sc2731.dtsi > > +++ b/arch/arm64/boot/dts/sprd/sc2731.dtsi > > @@ -97,7 +97,7 @@ pmic_adc: adc@480 { > > fuel-gauge@a00 { > > compatible = "sprd,sc2731-fgu"; > > reg = <0xa00>; > > - bat-detect-gpio = <&pmic_eic 9 GPIO_ACTIVE_HIGH>; > > + bat-detect-gpios = <&pmic_eic 9 GPIO_ACTIVE_HIGH>; > > io-channels = <&pmic_adc 3>, <&pmic_adc 6>; > > io-channel-names = "bat-temp", "charge-vol"; > > monitored-battery = <&bat>; > > -- > > 2.34.1 > > > > Hi all, > > looking at this patch again, it seems there's some confusion going on. > The bindings specify the property as "battery-detect-gpios", but the driver > checks for "bat-detect" [1]. I assume the DTS was added with "bat-detect" > to make it work, even though it's not conformant to bindings. > It has been this way since the bindings/driver/DTS were introduced > back in 2018/2019. > > What would be the correct way to fix this? Change the bindings to > "bat-detect-gpios" or change the driver/DTS to "battery-detect-gpios"? I would prefer the second, i.e. change to "battery-detect-gpios" in the driver and DTS. Thanks, Chunyan > > [1] https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/drivers/power/supply/sc27xx_fuel_gauge.c?h=v6.11#n1186 > > Regards, > Stanislav