On Mon, 2024-10-28 at 17:07 +0100, Uwe Kleine-König wrote:
> When during a measurement two channels are enabled, two measurements are
> done that are reported sequencially in the DATA register. As the code
> triggered by reading one of the sysfs properties expects that only one
> channel is enabled it only reads the first data set which might or might
> not belong to the intended channel.
>
> To prevent this situation disable all channels during probe. This fixes
> a problem in practise because the reset default for channel 0 is
> enabled. So all measurements before the first measurement on channel 0
> (which disables channel 0 at the end) might report wrong values.
>
> Fixes: 7b8d045e497a ("iio: adc: ad7124: allow more than 8 channels")
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxx>
> ---
Reviewed-by: Nuno Sa <nuno.sa@xxxxxxxxxx>
> drivers/iio/adc/ad7124.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/iio/adc/ad7124.c b/drivers/iio/adc/ad7124.c
> index a5d91933f505..749304d38415 100644
> --- a/drivers/iio/adc/ad7124.c
> +++ b/drivers/iio/adc/ad7124.c
> @@ -917,6 +917,9 @@ static int ad7124_setup(struct ad7124_state *st)
> * set all channels to this default value.
> */
> ad7124_set_channel_odr(st, i, 10);
> +
> + /* Disable all channels to prevent unintended conversions. */
> + ad_sd_write_reg(&st->sd, AD7124_CHANNEL(i), 2, 0);
> }
>
> ret = ad_sd_write_reg(&st->sd, AD7124_ADC_CONTROL, 2, st->adc_control);
