In the Pine64 PinePhone, the stk3310 chip is powered by a regulator that is disabled at system boot and can be shut off during suspend. To ensure that the chip properly initializes, both after boot and suspend, we need to manage this regulator. Additionally if the chip is shut off in suspend, we need to make sure that it gets reinitialized with the same parameters after resume. Major changes in v3: - Use bulk regulators instead of two individual ones - Replace stk3310_remove with devm callbacks - Hopefully I haven't missed anything, it's been a while since I worked on this patch, and I didn't take good enough notes Major changes in v2: - Add handling of the IR LED. I was hesitant to include this as it is the same as pull-up regulator for the i2c bus on the hardware I have, so I can't test it well. I think leaving it out is more likely to cause issues than including it. - Convert stk3310 to use dev_err_probe for errors. - Always enable / disable regulators and rely on dummy devices if they're not specified. - more listed in individual patches Aren Moynihan (5): dt-bindings: iio: light: stk33xx: add vdd and leda regulators iio: light: stk3310: handle all remove logic with devm callbacks iio: light: stk3310: Implement vdd and leda supplies iio: light: stk3310: use dev_err_probe where possible iio: light: stk3310: log error if reading the chip id fails Ondrej Jirman (1): arm64: dts: allwinner: pinephone: Add power supplies to stk3311 .../bindings/iio/light/stk33xx.yaml | 4 + .../dts/allwinner/sun50i-a64-pinephone.dtsi | 2 + drivers/iio/light/stk3310.c | 156 +++++++++++++----- 3 files changed, 118 insertions(+), 44 deletions(-) -- 2.47.0
