On 22.10.24 18:35, Conor Dooley wrote:
On Tue, Oct 22, 2024 at 11:28:54AM +0200, Philipp Rosenberger wrote:
The nxp,battery-switch-over property is used to control the switch-over,
battery low detection and extra power fail detection functions.
The PCF2131 has a different default value for the PWRMNG bits. It is set
to 0x7: battery switch-over function is disabled, only one power supply
(VDD); battery low detection function is disabled.
This is the opposite of the default of the PCF2127/PCA2129 and PCF2129.
With the nxp,battery-switch-over the behavior can be controlled through
the device tree.
Signed-off-by: Philipp Rosenberger <p.rosenberger@xxxxxxxxxx>
---
Documentation/devicetree/bindings/rtc/nxp,pcf2127.yaml | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/Documentation/devicetree/bindings/rtc/nxp,pcf2127.yaml b/Documentation/devicetree/bindings/rtc/nxp,pcf2127.yaml
index 2d9fe5a75b06..5739c3e371e7 100644
--- a/Documentation/devicetree/bindings/rtc/nxp,pcf2127.yaml
+++ b/Documentation/devicetree/bindings/rtc/nxp,pcf2127.yaml
@@ -30,6 +30,16 @@ properties:
reset-source: true
+ nxp,battery-switch-over:
+ description:
+ Battery and power related configuration. This property is used to set the
+ PWRMNG bits of the Control_3 register to control the battery switch-over,
+ battery low detection and extra power fail detection functions.
+ The actual supported functions depend on the device capabilities.
+ $ref: /schemas/types.yaml#/definitions/uint8
+ minimum: 0
+ maximum: 7
Beyond the fact that I dislike register-content properties like this, where
it is not possible to grok the meaning by reading the property, what
Yes, I'm not satisfied with this solution myself.
There are three different functions, which can be configured in the
register:
- battery switch-over mode: standard; direct; disabled
- battery low detection: enabled; disabled
- extra power fail detection: enabled; disabled
I'm not sure what a proper way is to implement this in the devicetree.
even makes this suitable for DT in the first place? Reading the commit
message this sounds like software policy, and that different users of
the same board might want to configure these register bits in different
ways.
It is less a software policy, but a configuration how the hardware is
implemented. If the device has no battery, it is possible to disable the
battery switch-over function. In this case the V_BAT must be connected
to ground.
If a battery is connected, the battery switchover will only work if the
battery switch-over function is in standard mode or direct switching mode.
Until now the driver has just ignored the PWRMNG bits. As the default
was battery switching in standard mode. Thus all use cases worked good
enough. Battery switching was working if a battery was connected. If no
battery was connected it did no real harm (the rtc may have used a tiny
bit more power then needed, I guess).
With the new PCF2131 the default has changed to battery switch-over
disabled. Now even with a battery attached, the rtc will lose time after
a power cycle.
I guess I should describe this better in the commit message.
