Adds bootph-* properties to the leaf nodes to enable bootloaders to
utilise them.
Following adds bootph-* to
- System controller nodes that allow controlling power domain, clocks, etc.
- secure_proxy_sa3/secure_proxy_main mboxes for communication with
System Controller
- mcu_ringacc/mcu_udmap for DMA to SMS
- chipid for detection soc information.
- mcu_timer0 for bootloader tick-timer.
- hbmc_mux for enabling Hyperflash support
- ESM nodes for enabling ESM support.
- wkup_vtm for enabling Adaptive voltage scaling(AVS) support
Signed-off-by: Manorit Chawdhry <m-chawdhry@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-j721e-main.dtsi | 2 ++
arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi | 10 ++++++++++
2 files changed, 12 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
index 0da785be80ff..af3d730154ac 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
@@ -226,6 +226,7 @@ secure_proxy_main: mailbox@32c00000 {
<0x00 0x32800000 0x00 0x100000>;
interrupt-names = "rx_011";
interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
+ bootph-all;
};
smmu0: iommu@36600000 {
@@ -2853,6 +2854,7 @@ main_spi7: spi@2170000 {
main_esm: esm@700000 {
compatible = "ti,j721e-esm";
reg = <0x0 0x700000 0x0 0x1000>;
+ bootph-pre-ram;
ti,esm-pins = <344>, <345>;
};
};
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
index 3731ffb4a5c9..cf5fb1160ada 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
@@ -21,16 +21,19 @@ dmsc: system-controller@44083000 {
k3_pds: power-controller {
compatible = "ti,sci-pm-domain";
#power-domain-cells = <2>;
+ bootph-all;
};
k3_clks: clock-controller {
compatible = "ti,k2g-sci-clk";
#clock-cells = <2>;
+ bootph-all;
};
k3_reset: reset-controller {
compatible = "ti,sci-reset";
#reset-cells = <2>;
+ bootph-all;
};
};
@@ -61,6 +64,7 @@ wkup_conf: bus@43000000 {
chipid: chipid@14 {
compatible = "ti,am654-chipid";
reg = <0x14 0x4>;
+ bootph-all;
};
};
@@ -112,6 +116,7 @@ mcu_timer0: timer@40400000 {
assigned-clocks = <&k3_clks 35 1>;
assigned-clock-parents = <&k3_clks 35 2>;
power-domains = <&k3_pds 35 TI_SCI_PD_EXCLUSIVE>;
+ bootph-pre-ram;
ti,timer-pwm;
/* Non-MPU Firmware usage */
status = "reserved";
@@ -362,6 +367,7 @@ hbmc_mux: mux-controller@47000004 {
reg = <0x00 0x47000004 0x00 0x4>;
#mux-control-cells = <1>;
mux-reg-masks = <0x0 0x2>; /* HBMC select */
+ bootph-all;
};
hbmc: hyperbus@47034000 {
@@ -470,6 +476,7 @@ mcu_ringacc: ringacc@2b800000 {
<0x0 0x2a500000 0x0 0x40000>,
<0x0 0x28440000 0x0 0x40000>;
reg-names = "rt", "fifos", "proxy_gcfg", "proxy_target", "cfg";
+ bootph-all;
ti,num-rings = <286>;
ti,sci-rm-range-gp-rings = <0x1>; /* GP ring range */
ti,sci = <&dmsc>;
@@ -489,6 +496,7 @@ mcu_udmap: dma-controller@285c0000 {
"tchan", "rchan", "rflow";
msi-parent = <&main_udmass_inta>;
#dma-cells = <1>;
+ bootph-all;
ti,sci = <&dmsc>;
ti,sci-dev-id = <236>;
@@ -509,6 +517,7 @@ secure_proxy_mcu: mailbox@2a480000 {
reg = <0x0 0x2a480000 0x0 0x80000>,
<0x0 0x2a380000 0x0 0x80000>,
<0x0 0x2a400000 0x0 0x80000>;
+ bootph-pre-ram;
/*
* Marked Disabled:
* Node is incomplete as it is meant for bootloaders and
@@ -687,6 +696,7 @@ wkup_vtm0: temperature-sensor@42040000 {
<0x00 0x43000300 0x00 0x10>;
power-domains = <&k3_pds 154 TI_SCI_PD_EXCLUSIVE>;
#thermal-sensor-cells = <1>;
+ bootph-pre-ram;
};
mcu_esm: esm@40800000 {
