Add the necessary DT changes to enable HDMI0 on FriendlyELEC NanoPC-T6.
Tested on LTS variant of the board but this part is the same on both.
Signed-off-by: Marcin Juszkiewicz <marcin.juszkiewicz@xxxxxxxxxx>
---
.../boot/dts/rockchip/rk3588-nanopc-t6.dtsi | 47 +++++++++++++++++++
1 file changed, 47 insertions(+)
diff --git a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
index fc131789b4c3..35d5d9f0c477 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
@@ -10,6 +10,7 @@
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include <dt-bindings/pinctrl/rockchip.h>
+#include <dt-bindings/soc/rockchip,vop2.h>
#include <dt-bindings/usb/pd.h>
#include "rk3588.dtsi"
@@ -40,6 +41,17 @@ chosen {
stdout-path = "serial2:1500000n8";
};
+ hdmi0-con {
+ compatible = "hdmi-connector";
+ type = "a";
+
+ port {
+ hdmi0_con_in: endpoint {
+ remote-endpoint = <&hdmi0_out_con>;
+ };
+ };
+ };
+
ir-receiver {
compatible = "gpio-ir-receiver";
gpios = <&gpio0 RK_PD4 GPIO_ACTIVE_LOW>;
@@ -318,6 +330,26 @@ &gpu {
status = "okay";
};
+&hdmi0 {
+ status = "okay";
+};
+
+&hdmi0_in {
+ hdmi0_in_vp0: endpoint {
+ remote-endpoint = <&vp0_out_hdmi0>;
+ };
+};
+
+&hdmi0_out {
+ hdmi0_out_con: endpoint {
+ remote-endpoint = <&hdmi0_con_in>;
+ };
+};
+
+&hdptxphy_hdmi0 {
+ status = "okay";
+};
+
&i2c0 {
pinctrl-names = "default";
pinctrl-0 = <&i2c0m2_xfer>;
@@ -1039,3 +1071,18 @@ &usb_host1_ehci {
&usb_host1_ohci {
status = "okay";
};
+
+&vop_mmu {
+ status = "okay";
+};
+
+&vop {
+ status = "okay";
+};
+
+&vp0 {
+ vp0_out_hdmi0: endpoint@ROCKCHIP_VOP2_EP_HDMI0 {
+ reg = <ROCKCHIP_VOP2_EP_HDMI0>;
+ remote-endpoint = <&hdmi0_in_vp0>;
+ };
+};
--
2.47.0
