Re: [PATCH v2 0/5] Enable HDMI0 on several RK3588 based boards

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



W dniu 19.10.2024 o 12:12, Cristian Ciocaltea pisze:
Since the initial support for the RK3588 HDMI TX Controller [1] has been
merged as of next-20241018, let's enable the HDMI0 output port for the
following boards: Radxa ROCK 5A & 5B, Rockchip RK3588 EVB1 V10, Xunlong
Orange Pi 5+.

I copied changes to FriendlyELEC NanoPC-T6 DT and booted 6.12-rc3 with your changes on LTS variant of the board.

With my SBC monitor it complained about resolution (10.5" 1366x768px):

rockchip-drm display-subsystem: [drm] *ERROR* vp0 Cluster0-win0 actual_w[1366] not 4 pixel aligned

And monitor told me "no signal".

/sys/devices/platform/display-subsystem/drm/card1/card1-HDMI-A-1/modes lists all resolutions available.

Would be nice to see system going to next EDID resolution in such case. 1280x720px is 4px aligned.


With my 34" 3440x1440px monitor it shown some output once. In resolution close to original one but 16:9 instead of 21:9 one. Anyway monitor behaved in "I do not like that signal" way - started blinking, had problems with displaying even from my desktop after.


I got a feeling that 1920x1080px monitor landed on my "need to buy" list.




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux