From: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
Hogging of gpio pins used as interrupts is not required, as the rzg2l
pinctrl driver sets the direction as input when the pin is requested
as GPIO interrupt.
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
---
.../boot/dts/renesas/rzg3s-smarc-som.dtsi | 18 ----------------
arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi | 21 -------------------
2 files changed, 39 deletions(-)
diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
index 71424e69939e..6e95933cd7ef 100644
--- a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
+++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
@@ -196,15 +196,6 @@ &sdhi2 {
#endif
&pinctrl {
-#if SW_CONFIG3 == SW_ON
- eth0-phy-irq-hog {
- gpio-hog;
- gpios = <RZG2L_GPIO(12, 0) GPIO_ACTIVE_LOW>;
- input;
- line-name = "eth0-phy-irq";
- };
-#endif
-
eth0_pins: eth0 {
txc {
pinmux = <RZG2L_PORT_PINMUX(1, 0, 1)>; /* ET0_TXC */
@@ -239,15 +230,6 @@ mux {
};
};
-#if SW_CONFIG3 == SW_ON
- eth1-phy-irq-hog {
- gpio-hog;
- gpios = <RZG2L_GPIO(12, 1) GPIO_ACTIVE_LOW>;
- input;
- line-name = "eth1-phy-irq";
- };
-#endif
-
eth1_pins: eth1 {
txc {
pinmux = <RZG2L_PORT_PINMUX(7, 0, 1)>; /* ET1_TXC */
diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi b/arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi
index 4509151344c4..baeca5ff5d61 100644
--- a/arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi
+++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi
@@ -71,27 +71,6 @@ &i2c0 {
};
&pinctrl {
- key-1-gpio-hog {
- gpio-hog;
- gpios = <RZG2L_GPIO(18, 0) GPIO_ACTIVE_LOW>;
- input;
- line-name = "key-1-gpio-irq";
- };
-
- key-2-gpio-hog {
- gpio-hog;
- gpios = <RZG2L_GPIO(0, 1) GPIO_ACTIVE_LOW>;
- input;
- line-name = "key-2-gpio-irq";
- };
-
- key-3-gpio-hog {
- gpio-hog;
- gpios = <RZG2L_GPIO(0, 3) GPIO_ACTIVE_LOW>;
- input;
- line-name = "key-3-gpio-irq";
- };
-
scif0_pins: scif0 {
pinmux = <RZG2L_PORT_PINMUX(6, 3, 1)>, /* RXD */
<RZG2L_PORT_PINMUX(6, 4, 1)>; /* TXD */
--
2.43.0
