On Fri, Oct 11, 2024 at 06:30:31PM +0900, Damien Le Moal wrote:
> On 10/10/24 19:49, Manivannan Sadhasivam wrote:
> >> +static int rockchip_pcie_ep_setup_irq(struct pci_epc *epc)
> >> +{
> >> + struct rockchip_pcie_ep *ep = epc_get_drvdata(epc);
> >> + struct rockchip_pcie *rockchip = &ep->rockchip;
> >> + struct device *dev = rockchip->dev;
> >> + int ret;
> >> +
> >> + if (!rockchip->ep_gpio)
> >> + return 0;
> >> +
> >> + /* PCIe reset interrupt */
> >> + ep->perst_irq = gpiod_to_irq(rockchip->ep_gpio);
> >> + if (ep->perst_irq < 0) {
> >> + dev_err(dev, "No corresponding IRQ for PERST GPIO\n");
> >> + return ep->perst_irq;
> >> + }
> >> +
> >> + ep->perst_asserted = true;
> >
> > How come?
>
> Yeah, a bit confusing. This is because the gpio active low / inactive high, so
> as soon as we enable the IRQ, we are going to get one IRQ even though perst gpio
> signal has not changed yet.
Which means you are looking for a wrong level! What is the polarity of the
PERST# gpio in DT?
- Mani
--
மணிவண்ணன் சதாசிவம்
