On Mon, Oct 07, 2024 at 12:02:34AM +0300, Dmitry Baryshkov wrote: > On Sun, Sep 29, 2024 at 07:29:07PM GMT, Jianhua Lu wrote: > > Add wifi node and this wifi module is connected to pice port. > > Could you please add ath11k probe messages to the log? We might need to > add an additional node with the calibration variant. > Hi, Dmitry. Do you mean that I should add ath11k probe message to the commit message? The following is ath11k probe message: [ 10.285469] ath11k_pci 0000:01:00.0: Adding to iommu group 12 [ 10.285637] ath11k_pci 0000:01:00.0: BAR 0 [mem 0x60400000-0x604fffff 64bit]: assigned [ 10.285699] ath11k_pci 0000:01:00.0: enabling device (0000 -> 0002) [ 10.286003] ath11k_pci 0000:01:00.0: MSI vectors: 32 [ 10.286023] ath11k_pci 0000:01:00.0: qca6390 hw2.0 [ 10.652407] ath11k_pci 0000:01:00.0: chip_id 0x0 chip_family 0xb board_id 0xff soc_id 0xffffffff [ 10.652429] ath11k_pci 0000:01:00.0: fw_version 0x10121492 fw_build_timestamp 2021-11-04 11:23 fw_build_id I'm not sure if it's necessary to add calibration variant because wifi works normally on this board without adding calibration variant.
