On Sun, Mar 22, 2015 at 12:00:55PM +0100, Hans de Goede wrote: > Hi, > > On 22-03-15 05:03, Dmitry Torokhov wrote: > >Hi Hans, > > > >On Tue, Mar 10, 2015 at 06:05:33PM +0100, Hans de Goede wrote: > >>+ error = devm_request_threaded_irq(dev, client->irq, NULL, icn8318_irq, > >>+ IRQF_TRIGGER_FALLING | IRQF_ONESHOT, > > > >Shouldn't we let DT data tell us what trigger to use? I.e. just leave > >IRQF_ONESHOT here? > > That is an interesting question, that new data is available is signalled by > the irq pin of the chip going low is a property of the chip, not the board > layout, so I believe it is best to leave this as is. My concern is that even if pin behavior is property of chip maybe on some boards we want to use level-triggered interrupts instead of edge? And if we indeed want to hard-code the trigger then shouldn't the binding document use onecell mapping (so that users do not attempt to configure triggers from DT)? > > Also note that if we want to get this from devicetree, that simply leaving out the > flag is not enough, we must specifically get the data from devicetree and pass > it into request_irq AFAICT. So the above would change to: > > irqflags = irqd_get_trigger_type(irq_get_irq_data(client->irq)) | IRQF_ONESHOT, > error = devm_request_threaded_irq(dev, client->irq, NULL, icn8318_irq, irqflags, No, of_irq_get() that i2c core calls before probing driver should already set the trigger type for us. There is no need for the individual drivers to do that. Thanks. -- Dmitry -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html