The veml6030 requires a delay of 4 ms after activating the sensor. That
is done correctly during the hw initialization, but it's missing after
resuming.
Move the delay to the power on function to make sure that it is always
observerd. When at it, use fsleep() instead of usleep_range() as such a
narrow range is not required.
Signed-off-by: Javier Carrasco <javier.carrasco.cruz@xxxxxxxxx>
---
drivers/iio/light/veml6030.c | 16 +++++++++++-----
1 file changed, 11 insertions(+), 5 deletions(-)
diff --git a/drivers/iio/light/veml6030.c b/drivers/iio/light/veml6030.c
index 4c436c5e0787..94e38a983cf3 100644
--- a/drivers/iio/light/veml6030.c
+++ b/drivers/iio/light/veml6030.c
@@ -144,8 +144,17 @@ static const struct attribute_group veml6030_event_attr_group = {
static int veml6030_als_pwr_on(struct veml6030_data *data)
{
- return regmap_clear_bits(data->regmap, VEML6030_REG_ALS_CONF,
- VEML6030_ALS_SD);
+ int ret;
+
+ ret = regmap_clear_bits(data->regmap, VEML6030_REG_ALS_CONF,
+ VEML6030_ALS_SD);
+ if (ret)
+ return ret;
+
+ /* Wait 4 ms to let processor & oscillator start correctly */
+ fsleep(4000);
+
+ return 0;
}
static int veml6030_als_shut_down(struct veml6030_data *data)
@@ -767,9 +776,6 @@ static int veml6030_hw_init(struct iio_dev *indio_dev)
return ret;
}
- /* Wait 4 ms to let processor & oscillator start correctly */
- usleep_range(4000, 4002);
-
/* Clear stale interrupt status bits if any during start */
ret = regmap_read(data->regmap, VEML6030_REG_ALS_INT, &val);
if (ret < 0) {
--
2.43.0
