On Thu, 2024-09-26 at 17:13 +0100, Conor Dooley wrote: > On Thu, Sep 26, 2024 at 03:03:18PM +0800, Andy-ld Lu wrote: > > Extend the devicetree bindings to include the MT8196 mmc controller > > by adding the compatible string 'mediatek,msdc-v2', which could be > > also used for future compatible SoCs that support new tx/rx. > > > > Add three properties for MT8196 settings: > > - 'mediatek,prohibit-gate-cg', indicate if the source clock CG > > could > > be disabled when CPU access IP registers. > > > > - 'mediatek,stop-dly-sel', configure read data clock stops at block > > gap. > > > > - 'mediatek,pop-en-cnt', configure the margins of write and read > > pointers while begin to pop data transfer. > > > > Signed-off-by: Andy-ld Lu <andy-ld.lu@xxxxxxxxxxxx> > > --- > > .../devicetree/bindings/mmc/mtk-sd.yaml | 26 > > +++++++++++++++++++ > > 1 file changed, 26 insertions(+) > > > > diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml > > b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml > > index c532ec92d2d9..82d1a9fac67c 100644 > > --- a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml > > +++ b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml > > @@ -25,6 +25,7 @@ properties: > > - mediatek,mt8173-mmc > > - mediatek,mt8183-mmc > > - mediatek,mt8516-mmc > > + - mediatek,msdc-v2 > > - items: > > - const: mediatek,mt7623-mmc > > - const: mediatek,mt2701-mmc > > @@ -154,6 +155,30 @@ properties: > > enum: [32, 64] > > default: 32 > > > > + mediatek,stop-dly-sel: > > + $ref: /schemas/types.yaml#/definitions/uint32 > > + description: > > + Some SoCs need to set appropriate stop-dly-sel to configure > > read data clock > > + stops at block gap. The valid range is from 0 to 0xf. > > If you used a specific compatible for these devices, which you > should, > you would not require either this or "pop-en-cnt". Thanks for your review. I will follow your comment in next change. > > > + minimum: 0 > > + maximum: 0xf > > + > > + mediatek,pop-en-cnt: > > + $ref: /schemas/types.yaml#/definitions/uint32 > > + description: > > + Some SoCs need to set appropriate pop-en-cnt to configure > > the margins of write > > + and read pointers while begin to pop data transfer. The > > valid range is from 0 > > + to 0xf. > > + minimum: 0 > > + maximum: 0xf > > + > > + mediatek,prohibit-gate-cg: > > This is also probably detectable from a specific compatible, if you > had > one? > TL;DR specific compatibles please, non of this "msdc-v2" stuff, > sorry. > > Thanks, > Conor. I will follow your comment in next change. > > > + $ref: /schemas/types.yaml#/definitions/flag > > + description: > > + Decide if source clock CG could be disabled when CPU access > > IP registers. > > + If present, source clock CG could not be disabled. > > + If not present, source clock CG could be disabled. > > + > > resets: > > maxItems: 1 > > > > @@ -191,6 +216,7 @@ allOf: > > - mediatek,mt8188-mmc > > - mediatek,mt8195-mmc > > - mediatek,mt8516-mmc > > + - mediatek,msdc-v2 > > then: > > properties: > > clocks: > > -- > > 2.46.0 > > > >
