Re: [PATCH 1/3] fpga: Add Efinix Trion & Titanium serial SPI programming driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 27/09/2024 16:14, iansdannapel@xxxxxxxxx wrote:
> From: Ian Dannapel <iansdannapel@xxxxxxxxx>
> 
> Add a new driver for loading binary firmware to volatile
> configuration RAM using "SPI passive programming" on Efinix FPGAs.
> 
> Signed-off-by: Ian Dannapel <iansdannapel@xxxxxxxxx>

Thank you for your patch. There is something to discuss/improve.

> ---
>  drivers/fpga/Kconfig                    |  10 ++
>  drivers/fpga/Makefile                   |   1 +
>  drivers/fpga/efinix-trion-spi-passive.c | 211 ++++++++++++++++++++++++
>  3 files changed, 222 insertions(+)
>  create mode 100644 drivers/fpga/efinix-trion-spi-passive.c
> 
> diff --git a/drivers/fpga/Kconfig b/drivers/fpga/Kconfig
> index 37b35f58f0df..eb1e44c4e3e0 100644
> --- a/drivers/fpga/Kconfig
> +++ b/drivers/fpga/Kconfig
> @@ -83,6 +83,16 @@ config FPGA_MGR_XILINX_SPI
>  	  FPGA manager driver support for Xilinx FPGA configuration
>  	  over slave serial interface.
>  
> +config FPGA_MGR_EFINIX_SPI
> +	tristate "Efinix FPGA configuration over SPI passive"
> +	depends on SPI
> +	help
> +	  This option enables support for the FPGA manager driver to
> +	  configure Efinix Trion and Titanium Series FPGAs over SPI
> +	  using passive serial mode.
> +	  Warning: Do not activate this if there are other SPI devices
> +	  on the same bus as it might interfere with the transmission.
> +
>  config FPGA_MGR_ICE40_SPI
>  	tristate "Lattice iCE40 SPI"
>  	depends on OF && SPI
> diff --git a/drivers/fpga/Makefile b/drivers/fpga/Makefile
> index aeb89bb13517..1a95124ff847 100644
> --- a/drivers/fpga/Makefile
> +++ b/drivers/fpga/Makefile
> @@ -18,6 +18,7 @@ obj-$(CONFIG_FPGA_MGR_TS73XX)		+= ts73xx-fpga.o
>  obj-$(CONFIG_FPGA_MGR_XILINX_CORE)	+= xilinx-core.o
>  obj-$(CONFIG_FPGA_MGR_XILINX_SELECTMAP)	+= xilinx-selectmap.o
>  obj-$(CONFIG_FPGA_MGR_XILINX_SPI)	+= xilinx-spi.o
> +obj-$(CONFIG_FPGA_MGR_EFINIX_SPI)	+= efinix-trion-spi-passive.o
>  obj-$(CONFIG_FPGA_MGR_ZYNQ_FPGA)	+= zynq-fpga.o
>  obj-$(CONFIG_FPGA_MGR_ZYNQMP_FPGA)	+= zynqmp-fpga.o
>  obj-$(CONFIG_FPGA_MGR_VERSAL_FPGA)	+= versal-fpga.o
> diff --git a/drivers/fpga/efinix-trion-spi-passive.c b/drivers/fpga/efinix-trion-spi-passive.c
> new file mode 100644
> index 000000000000..87ff645265ca
> --- /dev/null
> +++ b/drivers/fpga/efinix-trion-spi-passive.c
> @@ -0,0 +1,211 @@
> +// SPDX-License-Identifier: GPL-2.0-only
> +/*
> + * Trion and Titanium Series FPGA SPI Passive Programming Driver
> + *
> + * Copyright (C) 2024 iris-GmbH infrared & intelligent sensors
> + *
> + * Ian Dannapel <iansdannapel@xxxxxxxxx>
> + *
> + * Manage Efinix FPGA firmware that is loaded over SPI using
> + * the serial configuration interface.
> + */
> +
> +#include <linux/delay.h>
> +#include <linux/device.h>
> +#include <linux/fpga/fpga-mgr.h>
> +#include <linux/gpio/consumer.h>
> +#include <linux/module.h>
> +#include <linux/mod_devicetable.h>
> +#include <linux/of.h>
> +#include <linux/spi/spi.h>
> +#include <linux/sizes.h>
> +
> +struct efinix_spi_conf {
> +	struct spi_device *spi;
> +	struct gpio_desc *cdone;
> +	struct gpio_desc *creset;
> +	struct gpio_desc *cs;
> +};
> +
> +static int efinix_spi_get_cdone_gpio(struct efinix_spi_conf *conf)
> +{
> +	int ret;
> +
> +	ret = gpiod_get_value(conf->cdone);

This should be just return gpiod_get_value()... but then it's quite
simple wrapper, so just use it directly.

> +	return ret;
> +}
> +
> +static void efinix_spi_reset(struct efinix_spi_conf *conf)
> +{
> +	gpiod_set_value(conf->creset, 1);
> +	/* wait tCRESET_N */
> +	usleep_range(5, 15);
> +	gpiod_set_value(conf->creset, 0);
> +}
> +
> +static enum fpga_mgr_states efinix_spi_state(struct fpga_manager *mgr)
> +{
> +	struct efinix_spi_conf *conf = mgr->priv;
> +
> +	if (conf->cdone && efinix_spi_get_cdone_gpio(conf) == 1)
> +		return FPGA_MGR_STATE_OPERATING;
> +
> +	return FPGA_MGR_STATE_UNKNOWN;
> +}
> +
> +static int efinix_spi_apply_clk_cycles(struct efinix_spi_conf *conf)
> +{
> +	char data[13] = {0};
> +
> +	return spi_write(conf->spi, data, sizeof(data));

Hm, aren't buffers from stack discouraged? spi-summary explicitly
mentions this case or I am getting this wrong?

> +}
> +
> +static int efinix_spi_write_init(struct fpga_manager *mgr,
> +				 struct fpga_image_info *info,
> +				 const char *buf, size_t count)
> +{
> +	struct efinix_spi_conf *conf = mgr->priv;
> +
> +	if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) {
> +		dev_err(&mgr->dev, "Partial reconfiguration not supported\n");
> +		return -EINVAL;
> +	}
> +
> +	/* reset with chip select active */
> +	gpiod_set_value(conf->cs, 1);
> +	usleep_range(5, 15);
> +	efinix_spi_reset(conf);
> +
> +	/* wait tDMIN */
> +	usleep_range(100, 150);
> +
> +	return 0;
> +}
> +
> +static int efinix_spi_write(struct fpga_manager *mgr, const char *buf,
> +			    size_t count)
> +{
> +	struct efinix_spi_conf *conf = mgr->priv;
> +	int ret;
> +
> +	ret = spi_write(conf->spi, buf, count);
> +	if (ret) {
> +		dev_err(&mgr->dev, "SPI error in firmware write: %d\n",
> +			ret);
> +		return ret;
> +	}
> +
> +	return 0;
> +}
> +
> +static int efinix_spi_write_complete(struct fpga_manager *mgr,
> +				     struct fpga_image_info *info)
> +{
> +	struct efinix_spi_conf *conf = mgr->priv;
> +	unsigned long timeout =
> +		jiffies + usecs_to_jiffies(info->config_complete_timeout_us);
> +	bool expired = false;
> +	int done;
> +
> +	/* append at least 100 clock cycles */
> +	efinix_spi_apply_clk_cycles(conf);
> +
> +	/* release chip select */
> +	gpiod_set_value(conf->cs, 0);
> +
> +	if (conf->cdone) {
> +		while (!expired) {
> +			expired = time_after(jiffies, timeout);
> +
> +			done = efinix_spi_get_cdone_gpio(conf);
> +			if (done < 0)
> +				return done;
> +
> +			if (done)
> +				break;
> +		}
> +	}
> +
> +	if (expired)
> +		return -ETIMEDOUT;
> +
> +	/* wait tUSER */
> +	usleep_range(75, 125);
> +
> +	return 0;
> +}
> +
> +static const struct fpga_manager_ops efinix_spi_ops = {
> +	.state = efinix_spi_state,
> +	.write_init = efinix_spi_write_init,
> +	.write = efinix_spi_write,
> +	.write_complete = efinix_spi_write_complete,
> +};
> +
> +static int efinix_spi_probe(struct spi_device *spi)
> +{
> +	struct efinix_spi_conf *conf;
> +	struct fpga_manager *mgr;
> +
> +	conf = devm_kzalloc(&spi->dev, sizeof(*conf), GFP_KERNEL);
> +	if (!conf)
> +		return -ENOMEM;
> +
> +	conf->spi = spi;
> +
> +	conf->creset = devm_gpiod_get(&spi->dev, "creset", GPIOD_OUT_HIGH);
> +	if (IS_ERR(conf->creset))
> +		return dev_err_probe(&spi->dev, PTR_ERR(conf->creset),
> +				"Failed to get RESET gpio\n");
> +
> +	conf->cs = devm_gpiod_get(&spi->dev, "cs", GPIOD_OUT_HIGH);
> +	if (IS_ERR(conf->cs))
> +		return dev_err_probe(&spi->dev, PTR_ERR(conf->cs),
> +				"Failed to get CHIP_SELECT gpio\n");
> +
> +	if (!(spi->mode & SPI_CPHA) || !(spi->mode & SPI_CPOL))
> +		return dev_err_probe(&spi->dev, -EINVAL,
> +				"Unsupported SPI mode, set CPHA and CPOL\n");
> +
> +	conf->cdone = devm_gpiod_get_optional(&spi->dev, "cdone", GPIOD_IN);
> +	if (IS_ERR(conf->cdone))
> +		return dev_err_probe(&spi->dev, PTR_ERR(conf->cdone),
> +				"Failed to get CDONE gpio\n");
> +
> +	mgr = devm_fpga_mgr_register(&spi->dev,
> +				"Efinix SPI Passive Programming FPGA Manager",
> +					&efinix_spi_ops, conf);
> +
> +	return PTR_ERR_OR_ZERO(mgr);
> +}
> +
> +#ifdef CONFIG_OF

Drop

> +static const struct of_device_id efinix_spi_of_match[] = {
> +	{ .compatible = "efinix,trion-spi-passive", },
> +	{ .compatible = "efinix,titanium-spi-passive", },
> +	{}
> +};
> +MODULE_DEVICE_TABLE(of, efinix_spi_of_match);
> +#endif
> +
> +static const struct spi_device_id efinix_ids[] = {
> +	{ "trion-spi-passive", 0 },
> +	{ "titanium-spi-passive", 0 },
> +	{},
> +};
> +MODULE_DEVICE_TABLE(spi, efinix_ids);
> +
> +static struct spi_driver efinix_spi_passive_driver = {
> +	.driver = {
> +		.name = "efinix-fpga-spi-passive",
> +		.of_match_table = of_match_ptr(efinix_spi_of_match),

Drop of_match_ptr


Best regards,
Krzysztof





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux