On 9/26/24 14:09, Sean Anderson wrote: > Linux can configure almost every part of this clock generator without > relying on the OTP settings. However, the correct configuration for the > SD/OE pin cannot be determined automatically. Therefore, add the > appropriate properties to configure this pin. > > I have CC'd some people who appear to have access to the following > boards which use the versaclock5: > > - Salvator-X > - HiHope RZ/G2[MN] Main Board > - Beacon Embedded Works RZ/G2N Development Kit > > as I could not find schematics for these boards. You can help me out by > (pick one): > > - Run the following command and send me the output: > > $ grep 10: /sys/kernel/debug/regmap/*-006a/registers > > - Measure the voltage on the SD/OE pin on a functioning board. > - Inspect (or send me) the schematic to determine the state of the SD/OE > pin during normal operation. > > My suspicion is that all of these boards use the same configuration > (SD/OE pin tied high) owing to their common design heritage. Thanks in > advance. +CC the people I meant to CC in the first place
