On Wed, 20 Mar 2024 00:33:50 +0100
Kamil Kasperski <ressetkk@xxxxxxxxx> wrote:
Hi Kamil,
> W dniu 20.03.2024 o 00:22, Andre Przywara pisze:
> > On Tue, 19 Mar 2024 18:50:24 +0100
> > Kamil Kasperski <ressetkk@xxxxxxxxx> wrote:
> >
> > Hi Kamil,
> >
> >> Add dtsi file for T95 tv boxes and add initial support for T95 5G AXP313A
> >> variant with a board name H616-T95MAX-AXP313A-v3.0 Internal storage is not
> >> accessible due to lack of support for H616 NAND controller.
> >>
> >> Signed-off-by: Kamil Kasperski <ressetkk@xxxxxxxxx>
> > thanks for the changes, looks good now, although a bit minimal ;-)
> >
> > Reviewed-by: Andre Przywara <andre.przywara@xxxxxxx>
> >
> > Please can you wait till the -rc1 release on Sunday, and send a rebased
> > version next week? There is a small merge conflict in the dts Makefile
> > as of now.
> >
> > Cheers,
> > Andre
>
> Sure, no problem. Thank you very much for a review.
It's been a while, but can you maybe send a rebased version of this
patch set again? The merge window has just opened, so exactly now is
probably not a good time, but if you rebase on v6.12-rc1, due to be
released on the 29th September, we can get this queued.
Some minor things I just spotted below:
> Once it gets merged I'll get back to u-boot patch.
>
> Cheers,
> Kamil
>
> >
> >> ---
> >> arch/arm64/boot/dts/allwinner/Makefile | 1 +
> >> arch/arm64/boot/dts/allwinner/sun50i-h616-t95.dtsi | 109 +++++++++++++++++++++
> >> .../dts/allwinner/sun50i-h616-t95max-axp313.dts | 84 ++++++++++++++++
> >> 3 files changed, 194 insertions(+)
> >>
> >> diff --git a/arch/arm64/boot/dts/allwinner/Makefile b/arch/arm64/boot/dts/allwinner/Makefile
> >> index 21149b346a60..294921f12b73 100644
> >> --- a/arch/arm64/boot/dts/allwinner/Makefile
> >> +++ b/arch/arm64/boot/dts/allwinner/Makefile
> >> @@ -42,6 +42,7 @@ dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h6-tanix-tx6-mini.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-bigtreetech-cb1-manta.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-bigtreetech-pi.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-orangepi-zero2.dtb
> >> +dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-t95max-axp313.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-x96-mate.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h618-longanpi-3h.dtb
> >> dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h618-orangepi-zero2w.dtb
> >> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h616-t95.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h616-t95.dtsi
> >> new file mode 100644
> >> index 000000000000..4c02408733bc
> >> --- /dev/null
> >> +++ b/arch/arm64/boot/dts/allwinner/sun50i-h616-t95.dtsi
> >> @@ -0,0 +1,109 @@
> >> +// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
> >> +/*
> >> + * Copyright (C) 2024 Kamil Kasperski <ressetkk@xxxxxxxxx>
> >> + *
> >> + * Common DT nodes for H616-based T95 TV boxes
> >> + * There are two versions reported with different PMIC variants.
> >> + */
> >> +
> >> +#include "sun50i-h616.dtsi"
> >> +
> >> +#include <dt-bindings/gpio/gpio.h>
> >> +#include <dt-bindings/interrupt-controller/arm-gic.h>
> >> +
> >> +/ {
> >> + aliases {
> >> + ethernet1 = &sdio_wifi;
> >> + serial0 = &uart0;
> >> + };
> >> +
> >> + chosen {
> >> + stdout-path = "serial0:115200n8";
> >> + };
> >> +
> >> + reg_vcc5v: vcc5v {
> >> + /* board wide 5V supply directly from the DC input */
> >> + compatible = "regulator-fixed";
> >> + regulator-name = "vcc-5v";
> >> + regulator-min-microvolt = <5000000>;
> >> + regulator-max-microvolt = <5000000>;
> >> + regulator-always-on;
> >> + };
> >> +
> >> + reg_vcc3v3: vcc3v3 {
> >> + /* discrete 3.3V regulator */
> >> + compatible = "regulator-fixed";
> >> + regulator-name = "vcc-3v3";
> >> + regulator-min-microvolt = <3300000>;
> >> + regulator-max-microvolt = <3300000>;
> >> + regulator-always-on;
Can you please add a line:
vin-supply = <®_vcc5v>;
here, to not leave this regulator dangling? That should also suppress a
warning about a dummy regulator.
> >> + };
> >> +
> >> + wifi_pwrseq: pwrseq {
> >> + compatible = "mmc-pwrseq-simple";
> >> + clocks = <&rtc CLK_OSC32K_FANOUT>;
> >> + clock-names = "ext_clock";
> >> + pinctrl-0 = <&x32clk_fanout_pin>;
> >> + pinctrl-names = "default";
> >> + reset-gpios = <&pio 6 18 GPIO_ACTIVE_LOW>; /* PG18 */
> >> + };
> >> +};
> >> +
> >> +&ehci0 {
> >> + status = "okay";
> >> +};
> >> +
> >> +&ehci2 {
> >> + status = "okay";
> >> +};
> >> +
> >> +&ir {
> >> + status = "okay";
> >> +};
> >> +
> >> +&mmc0 {
> >> + cd-gpios = <&pio 8 16 GPIO_ACTIVE_LOW>; /* PI16 */
> >> + bus-width = <4>;
> >> + status = "okay";
Please add a:
disable-wp;
here, as microSD slots don't have a write-protect switch. We are in the
process of fixing all sunxi arm64 boards in this respect, but this DT would
probably miss that effort.
> >> +};
> >> +
> >> +&mmc1 {
> >> + mmc-pwrseq = <&wifi_pwrseq>;
> >> + bus-width = <4>;
> >> + non-removable;
> >> + status = "okay";
> >> +
> >> + sdio_wifi: wifi@1 {
> >> + reg = <1>;
> >> + };
> >> +};
> >> +
> >> +&ohci0 {
> >> + status = "okay";
> >> +};
> >> +
> >> +&ohci2 {
> >> + status = "okay";
> >> +};
> >> +
> >> +&uart0 {
> >> + pinctrl-names = "default";
> >> + pinctrl-0 = <&uart0_ph_pins>;
> >> + status = "okay";
> >> +};
> >> +
> >> +&uart1 {
> >> + pinctrl-names = "default";
> >> + pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
> >> + uart-has-rtscts;
> >> + status = "okay";
As Jernej mentioned: this is probably for connecting to the Bluetooth part
of the WiFi chip, so please add a least a comment here. And I wonder if we
know what Bluetooth IP this is, and if there is a compatible string for
that? Does the vendor firmware give any clue here?
Cheers,
Andre
> >> +};
> >> +
> >> +&usbotg {
> >> + dr_mode = "host"; /* USB A type receptable */
> >> + status = "okay";
> >> +};
> >> +
> >> +&usbphy {
> >> + status = "okay";
> >> +};
> >> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h616-t95max-axp313.dts b/arch/arm64/boot/dts/allwinner/sun50i-h616-t95max-axp313.dts
> >> new file mode 100644
> >> index 000000000000..08a6b4fcc235
> >> --- /dev/null
> >> +++ b/arch/arm64/boot/dts/allwinner/sun50i-h616-t95max-axp313.dts
> >> @@ -0,0 +1,84 @@
> >> +// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
> >> +/*
> >> + * Copyright (C) 2024 Kamil Kasperski <ressetkk@xxxxxxxxx>
> >> + *
> >> + * Configuration for T95 TV box with board label H616-T95MAX-AXP313A-v3.0
> >> + */
> >> +
> >> +/dts-v1/;
> >> +
> >> +#include "sun50i-h616-t95.dtsi"
> >> +
> >> +/ {
> >> + model = "T95 5G (AXP313)";
> >> + compatible = "t95,t95max-axp313", "allwinner,sun50i-h616";
> >> +};
> >> +
> >> +&mmc0 {
> >> + vmmc-supply = <®_dldo1>;
> >> +};
> >> +
> >> +&mmc1 {
> >> + vmmc-supply = <®_dldo1>;
> >> + vqmmc-supply = <®_aldo1>;
> >> +};
> >> +
> >> +&r_i2c {
> >> + status = "okay";
> >> +
> >> + axp313: pmic@36 {
> >> + compatible = "x-powers,axp313a";
> >> + reg = <0x36>;
> >> + #interrupt-cells = <1>;
> >> + interrupt-controller;
> >> +
> >> + vin1-supply = <®_vcc5v>;
> >> + vin2-supply = <®_vcc5v>;
> >> + vin3-supply = <®_vcc5v>;
> >> +
> >> + regulators {
> >> + reg_aldo1: aldo1 {
> >> + regulator-always-on;
> >> + regulator-min-microvolt = <1800000>;
> >> + regulator-max-microvolt = <1800000>;
> >> + regulator-name = "vcc1v8";
> >> + };
> >> +
> >> + reg_dldo1: dldo1 {
> >> + regulator-always-on;
> >> + regulator-min-microvolt = <3300000>;
> >> + regulator-max-microvolt = <3300000>;
> >> + regulator-name = "vcc3v3";
> >> + };
> >> +
> >> + reg_dcdc1: dcdc1 {
> >> + regulator-always-on;
> >> + regulator-min-microvolt = <810000>;
> >> + regulator-max-microvolt = <990000>;
> >> + regulator-name = "vdd-gpu-sys";
> >> + };
> >> +
> >> + reg_dcdc2: dcdc2 {
> >> + regulator-always-on;
> >> + regulator-min-microvolt = <810000>;
> >> + regulator-max-microvolt = <1100000>;
> >> + regulator-name = "vdd-cpu";
> >> + };
> >> +
> >> + reg_dcdc3: dcdc3 {
> >> + regulator-always-on;
> >> + regulator-min-microvolt = <1500000>;
> >> + regulator-max-microvolt = <1500000>;
> >> + regulator-name = "vdd-dram";
> >> + };
> >> + };
> >> + };
> >> +};
> >> +
> >> +&pio {
> >> + vcc-pc-supply = <®_aldo1>;
> >> + vcc-pf-supply = <®_dldo1>;
> >> + vcc-pg-supply = <®_aldo1>;
> >> + vcc-ph-supply = <®_dldo1>;
> >> + vcc-pi-supply = <®_dldo1>;
> >> +};
> >>
>
