From: Ricky CX Wu <ricky.cx.wu.wiwynn@xxxxxxxxx>
Changelog:
- v18
- Fix warnings for reg_format reporting by dts checking tool.
- v17
- Add SoB for the patches.
- v16
- Reorganized the patches.
- Add i2c-mux and resolve the dt-validate errors.
- Revise Yosemite 4 devicetree for devices behind i2c-mux.
- Add mctp config and sensors for NIC after i2c-mux on bus 15.
- Add fan led config for BMC to control according the status of fan.
- v15
- Add ISL28022 support
- v14
- Add SQ52205 support
- Add GPIO I6 pin
- v13
- Add RTQ6056-support-on-bus-11
- v12
- Fix GPIO linename typo and add missing GPIO pin initial state.
- v11
- Revise all GPIO line name with bottom line
- v10
- adjust mgm cpld ioexp bus
- add GPIOO7 name
- remove mctp driver
- v9
- add XDP710 support
- add RTQ6056 support
- add MP5990 support
- v8
- add fan led config
- v7
- Revise pca9506 i2c address
- v6
- Revise i2c duty-cycle for meeting 400khz spec
- v5
- Support medusa board adc sensors
- support NIC eeprom
- v4
- Re-format gpio linename
- Revise i2c device node names
- Split patches by logic changes
- v3
- Correct patch for revising gpio name
- v2
- Revise mx31790 fan tach config
- Add mctp config for NIC
- Support mux to cpld
- Revise gpio name
- v1
- Add gpio and eeprom behind i2c-mux
- Remove redundant idle-state setting for i2c-mux
- Enable adc 15, wdt2,spi gpio for yosemite4 use
- Revise quad mode to dual mode to avoid WP pin influnece the SPI
- Revise power sensor adm1281 for yosemite4 schematic change
- Add gpio pca9506 I/O expander for yosemite4 use
- remove space for adm1272 compatible
- enable interrupt setting for pca9555
- add eeprom for yosemite4 medusa board/BSM use
- remove temperature sensor for yosemite4 schematic change
- add power sensor for power module reading
- Revise adc128d818 adc mode for yosemite4 schematic change
- Revise ina233 for yosemite4 schematic change
- Remove idle state setting for yosemite4 NIC connection
- Initialize bmc gpio state
- Revise mx31790 fan tach config
- Add mctp config for NIC
- Support mux to cpld
- Revise gpio name
Ricky CX Wu (3):
ARM: dts: aspeed: yosemite4: Revise i2c-mux devices
ARM: dts: aspeed: yosemite4: add mctp config and sensors for NIC
ARM: dts: aspeed: yosemite4: add fan led config
.../aspeed/aspeed-bmc-facebook-yosemite4.dts | 706 ++++++++++++++++--
1 file changed, 660 insertions(+), 46 deletions(-)
--
2.25.1
