> +&gmac1 {
> + assigned-clocks = <&cru SCLK_GMAC1_RX_TX>, <&cru SCLK_GMAC1>;
> + assigned-clock-parents = <&cru SCLK_GMAC1_RGMII_SPEED>;
> + assigned-clock-rates = <0>, <125000000>;
> + clock_in_out = "output";
> + phy-handle = <&rgmii_phy1>;
> + phy-mode = "rgmii";
> + phy-supply = <&vcc_3v3>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&gmac1m1_miim
> + &gmac1m1_tx_bus2
> + &gmac1m1_rx_bus2
> + &gmac1m1_rgmii_clk
> + &gmac1m1_rgmii_bus>;
> + snps,reset-gpio = <&gpio4 RK_PC0 GPIO_ACTIVE_LOW>;
> + snps,reset-active-low;
> + snps,reset-delays-us = <0 20000 100000>;
> + tx_delay = <0x38>;
> + rx_delay = <0x15>;
> + status = "okay";
This has been discussed a few times. You should be using phy-mode
rgmii-id.
arch/arm/boot/dts/rockchip/rk3288-phycore-som.dtsi is i think also a
YT8521SC.
Andrew
