[PATCH 2/3] arm64: dts: allwinner: a64: Add WiFi/BT header on SoPine

[Peter Robinson <pbrobinson@xxxxxxxxx>]

This adds all the pin mappings on the WiFi/BT header on
the SoPine baseboard/A64-LTS. They're disabled by default
as the modules don't ship by default. This includes, where
they haven't been already, UART1 for BT and mmc1 for WiFi.

Signed-off-by: Peter Robinson <pbrobinson@xxxxxxxxx>
---
 .../allwinner/sun50i-a64-sopine-baseboard.dts | 24 +++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
index be2347c8f267..752d2aae8465 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
@@ -42,6 +42,11 @@ reg_vcc1v8: vcc1v8 {
 		regulator-min-microvolt = <1800000>;
 		regulator-max-microvolt = <1800000>;
 	};
+
+	wifi_pwrseq: pwrseq {
+		compatible = "mmc-pwrseq-simple";
+		reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
+	};
 };
 
 &ac_power_supply {
@@ -103,6 +108,17 @@ ext_rgmii_phy: ethernet-phy@1 {
 	};
 };
 
+/* On Wifi/BT connector */
+&mmc1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc1_pins>;
+	vmmc-supply = <&reg_dldo4>;
+	vqmmc-supply = <&reg_eldo1>;
+	mmc-pwrseq = <&wifi_pwrseq>;
+	bus-width = <4>;
+	non-removable;
+};
+
 &mmc2 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc2_pins>;
@@ -175,6 +191,14 @@ &uart0 {
 	status = "okay";
 };
 
+/* On Wifi/BT connector, with RTS/CTS */
+&uart1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+	uart-has-rtscts;
+	status = "disabled";
+};
+
 /* On Pi-2 connector */
 &uart2 {
 	pinctrl-names = "default";
-- 
2.46.0