Add support for COMBOPHY which is used either by the USB3 and PCIe controller. USB3 or PCIe mode is done with phy_set_mode(). PCIe internal reference clock can be generated from the internal clock source or optionnaly from an external 100Mhz pad. Signed-off-by: Christian Bruel <christian.bruel@xxxxxxxxxxx> --- arch/arm64/boot/dts/st/stm32mp251.dtsi | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) diff --git a/arch/arm64/boot/dts/st/stm32mp251.dtsi b/arch/arm64/boot/dts/st/stm32mp251.dtsi index 1167cf63d7e8..0d38763d9317 100644 --- a/arch/arm64/boot/dts/st/stm32mp251.dtsi +++ b/arch/arm64/boot/dts/st/stm32mp251.dtsi @@ -7,6 +7,7 @@ #include <dt-bindings/interrupt-controller/arm-gic.h> #include <dt-bindings/reset/st,stm32mp25-rcc.h> #include <dt-bindings/regulator/st,stm32mp25-regulator.h> +#include <dt-bindings/phy/phy.h> / { #address-cells = <2>; @@ -518,6 +519,22 @@ i2c8: i2c@46040000 { status = "disabled"; }; + combophy: phy@480c0000 { + compatible = "st,stm32mp25-combophy"; + reg = <0x480c0000 0x1000>; + #phy-cells = <1>; + clocks = <&rcc CK_BUS_USB3PCIEPHY>, <&rcc CK_KER_USB3PCIEPHY>; + clock-names = "apb", "ker"; + resets = <&rcc USB3PCIEPHY_R>; + reset-names = "phy"; + st,syscfg = <&syscfg>; + access-controllers = <&rifsc 67>; + power-domains = <&CLUSTER_PD>; + wakeup-source; + interrupts-extended = <&exti1 45 IRQ_TYPE_EDGE_FALLING>; + status = "disabled"; + }; + sdmmc1: mmc@48220000 { compatible = "st,stm32mp25-sdmmc2", "arm,pl18x", "arm,primecell"; arm,primecell-periphid = <0x00353180>; -- 2.34.1