Add the UFS Host Controller node. This was basically copied from the arch/arm64/boot/dts/qcom/sc7180.dtsi file. Signed-off-by: Marcus Glocker <marcus@xxxxxxxxx> Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/x1e80100.dtsi | 72 ++++++++++++++++++++++++++ 1 file changed, 72 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi index 7bca5fcd7d52..9f01b3ff3737 100644 --- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi +++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi @@ -2878,6 +2878,78 @@ mmss_noc: interconnect@1780000 { #interconnect-cells = <2>; }; + ufs_mem_hc: ufs@1d84000 { + compatible = "qcom,x1e80100-ufshc", "qcom,ufshc", + "jedec,ufs-2.0"; + reg = <0 0x01d84000 0 0x3000>; + interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>; + phys = <&ufs_mem_phy>; + phy-names = "ufsphy"; + lanes-per-direction = <1>; + #reset-cells = <1>; + resets = <&gcc GCC_UFS_PHY_BCR>; + reset-names = "rst"; + + power-domains = <&gcc GCC_UFS_PHY_GDSC>; + + iommus = <&apps_smmu 0xa0 0x0>; + + clock-names = "core_clk", + "bus_aggr_clk", + "iface_clk", + "core_clk_unipro", + "ref_clk", + "tx_lane0_sync_clk", + "rx_lane0_sync_clk"; + clocks = <&gcc GCC_UFS_PHY_AXI_CLK>, + <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>, + <&gcc GCC_UFS_PHY_AHB_CLK>, + <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>, + <&rpmhcc RPMH_CXO_CLK>, + <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>, + <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>; + freq-table-hz = <50000000 200000000>, + <0 0>, + <0 0>, + <37500000 150000000>, + <0 0>, + <0 0>, + <0 0>; + + interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS + &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>, + <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS + &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ALWAYS>; + interconnect-names = "ufs-ddr", "cpu-ufs"; + + qcom,ice = <&ice>; + + status = "disabled"; + }; + + ufs_mem_phy: phy@1d87000 { + compatible = "qcom,x1e80100-qmp-ufs-phy"; + reg = <0 0x01d87000 0 0x1000>; + clocks = <&rpmhcc RPMH_CXO_CLK>, + <&gcc GCC_UFS_PHY_PHY_AUX_CLK>, + <&tcsr TCSR_UFS_PHY_CLKREF_EN>; + clock-names = "ref", + "ref_aux", + "qref"; + power-domains = <&gcc GCC_UFS_PHY_GDSC>; + resets = <&ufs_mem_hc 0>; + reset-names = "ufsphy"; + #phy-cells = <0>; + status = "disabled"; + }; + + ice: crypto@1d90000 { + compatible = "qcom,x1e80100-inline-crypto-engine", + "qcom,inline-crypto-engine"; + reg = <0 0x01d90000 0 0x8000>; + clocks = <&gcc GCC_UFS_PHY_ICE_CORE_CLK>; + }; + pcie6a: pci@1bf8000 { device_type = "pci"; compatible = "qcom,pcie-x1e80100"; -- 2.39.2