On Thu, Aug 08, 2024 at 02:13:01PM +0200, Krzysztof Kozlowski wrote: > On 08/08/2024 14:01, Manivannan Sadhasivam wrote: > > On Mon, Aug 05, 2024 at 07:18:04PM +0200, Krzysztof Kozlowski wrote: > >> On 05/08/2024 19:07, Bjorn Andersson wrote: > >>> On Mon, Aug 05, 2024 at 09:41:26AM +0530, Krishna Chaitanya Chundru wrote: > >>>> On 8/4/2024 2:23 PM, Krzysztof Kozlowski wrote: > >>>>> On 03/08/2024 05:22, Krishna chaitanya chundru wrote: > >>>>>> diff --git a/Documentation/devicetree/bindings/pci/qcom,qps615.yaml b/Documentation/devicetree/bindings/pci/qcom,qps615.yaml > >>> [..] > >>>>>> + qps615,axi-clk-freq-hz: > >>>>>> + description: > >>>>>> + AXI clock which internal bus of the switch. > >>>>> > >>>>> No need, use CCF. > >>>>> > >>>> ack > >>> > >>> This is a clock that's internal to the QPS615, so there's no clock > >>> controller involved and hence I don't think CCF is applicable. > >> > >> AXI does not sound that internal. > > > > Well, AXI is applicable to whatever entity that implements it. We mostly seen it > > in ARM SoCs (host), but in this case the PCIe switch also has a microcontroller > > /processor of some sort, so AXI is indeed relevant for it. The naming actually > > comes from the switch's i2c register name that is being configured in the driver > > based on this property value. > > > >> DT rarely needs to specify internal > >> clock rates. What if you want to define rates for 20 clocks? Even > >> clock-frequency is deprecated, so why this would be allowed? > >> bus-frequency is allowed for buses, but that's not the case here, I guess? > >> > > > > This clock frequency is for the switch's internal AXI bus that runs at default > > 200MHz. And this property is used to specify a frequency that is configured over > > the i2c interface so that the switch's AXI bus can operate in a low frequency > > there by reducing the power consumption of the switch. > > > > It is not strictly needed for the switch operation, but for power optimization. > > So this property can also be dropped for the initial submission and added later > > if you prefer. > > So if the clock rate can change, why this is static in DTB? Or why this > is configurable per-board? > Because, board manufacturers can change the frequency depending on the switch configuration (enablement of DSP's etc...) > There is a reason why clock-frequency property is not welcomed and you > are re-implementing it. > Hmm, I'm not aware that 'clock-frequency' is not encouraged these days. So you are suggesting to change the rate in the driver itself based on the switch configuration? If so, what difference does it make? And no more *-freq properties are allowed? - Mani -- மணிவண்ணன் சதாசிவம்
