Fxtec Pro1x uses the same display (BOE BF060Y8M-AJ0) as Pro1.
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Signed-off-by: Dang Huynh <danct12@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm6115-fxtec-pro1x.dts | 84 +++++++++++++++++++++++--
1 file changed, 80 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sm6115-fxtec-pro1x.dts b/arch/arm64/boot/dts/qcom/sm6115-fxtec-pro1x.dts
index 67946d099976..0301f04041e7 100644
--- a/arch/arm64/boot/dts/qcom/sm6115-fxtec-pro1x.dts
+++ b/arch/arm64/boot/dts/qcom/sm6115-fxtec-pro1x.dts
@@ -33,6 +33,26 @@ framebuffer0: framebuffer@5c000000 {
};
};
+ disp_elvdd_supply: disp-elvdd-supply {
+ compatible = "regulator-fixed";
+ regulator-name = "disp_elvdd_supply";
+ };
+
+ disp_elvss_supply: disp-elvss-supply {
+ compatible = "regulator-fixed";
+ regulator-name = "disp_elvss_supply";
+ };
+
+ disp_vcc_supply: disp-vcc-supply {
+ compatible = "regulator-fixed";
+ regulator-name = "disp_vcc_supply";
+ };
+
+ disp_vci_supply: disp-vci-supply {
+ compatible = "regulator-fixed";
+ regulator-name = "disp_vci_supply";
+ };
+
gpio-keys {
compatible = "gpio-keys";
@@ -93,13 +113,16 @@ ts_vddio_supply: ts-vddio-supply {
};
};
-&dispcc {
- /* HACK: disable until a panel driver is ready to retain simplefb */
- status = "disabled";
+&gpi_dma0 {
+ status = "okay";
};
-&gpi_dma0 {
+&gpu {
status = "okay";
+
+ zap-shader {
+ firmware-name = "qcom/sm6115/Fxtec/QX1050/a610_zap.mbn";
+ };
};
&i2c1 {
@@ -136,6 +159,46 @@ touchscreen@14 {
};
};
+&mdss {
+ status = "okay";
+};
+
+&mdss_dsi0 {
+ vdda-supply = <&pm6125_l18a>;
+ status = "okay";
+
+ panel: panel@0 {
+ compatible = "boe,bf060y8m-aj0";
+ reg = <0>;
+
+ reset-gpios = <&tlmm 82 GPIO_ACTIVE_LOW>;
+
+ elvdd-supply = <&disp_elvdd_supply>;
+ elvss-supply = <&disp_elvss_supply>;
+ vcc-supply = <&disp_vcc_supply>;
+ vci-supply = <&disp_vci_supply>;
+ vddio-supply = <&pm6125_l9a>;
+
+ pinctrl-0 = <&mdss_dsi_n &panel_en_n>;
+ pinctrl-names = "default";
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <&mdss_dsi0_out>;
+ };
+ };
+ };
+};
+
+&mdss_dsi0_out {
+ data-lanes = <0 1 2 3>;
+ remote-endpoint = <&panel_in>;
+};
+
+&mdss_dsi0_phy {
+ status = "okay";
+};
+
&pm6125_gpios {
vol_up_n: vol-up-n-state {
pins = "gpio5";
@@ -338,6 +401,12 @@ key_camera_n: key-camera-n-state {
bias-pull-up;
};
+ panel_en_n: panel-en-n-state {
+ pins = "gpio65";
+ function = "gpio";
+ bias-disable;
+ };
+
ts_rst_n: ts-rst-n-state {
pins = "gpio71";
function = "gpio";
@@ -352,6 +421,13 @@ ts_int_n: ts-int-n-state {
bias-pull-up;
};
+ mdss_dsi_n: mdss-dsi-n-state {
+ pins = "gpio82";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-disable;
+ };
+
hall_sensor_n: hall-sensor-n-state {
pins = "gpio96";
function = "gpio";
--
2.46.0
