On 07/30/2024, Krzysztof Kozlowski wrote:
> On 30/07/2024 11:42, Liu Ying wrote:
>> On 07/30/2024, Krzysztof Kozlowski wrote:
>>> On 30/07/2024 08:55, Liu Ying wrote:
>>>> On 07/28/2024, Dmitry Baryshkov wrote:
>>>>> On Fri, Jul 12, 2024 at 05:32:34PM GMT, Liu Ying wrote:
>>>>>> i.MX8qxp Display Controller pixel engine consists of all processing
>>>>>> units that operate in the AXI bus clock domain. Add drivers for
>>>>>> ConstFrame, ExtDst, FetchLayer, FetchWarp and LayerBlend units, as
>>>>>> well as a pixel engine driver, so that two displays with primary
>>>>>> planes can be supported. The pixel engine driver as a master binds
>>>>>> those unit drivers as components. While at it, the pixel engine
>>>>>> driver is a component to be bound with the upcoming DRM driver.
>>>>>
>>>>> Same question / comment: create subnodes directly, without going
>>>>> through the subdevices. A lot of small functions that would benefit
>>>>> being inlined.
>>>>
>>>> Like I replied in patch 06/16, I can't create sub devices directly.
>>>>
>>>> Can you please point out typical ones for those small functions if
>>>> the comment still stands?
>>>>
>>>>>
>>>>>> +static int dc_cf_bind(struct device *dev, struct device *master, void *data)
>>>>>> +{
>>>>>> + struct platform_device *pdev = to_platform_device(dev);
>>>>>> + struct dc_drm_device *dc_drm = data;
>>>>>> + struct dc_pe *pe = dc_drm->pe;
>>>>>> + struct dc_cf_priv *priv;
>>>>>> + int id;
>>>>>> +
>>>>>> + priv = drmm_kzalloc(&dc_drm->base, sizeof(*priv), GFP_KERNEL);
>>>>>> + if (!priv)
>>>>>> + return -ENOMEM;
>>>>>> +
>>>>>> + priv->reg_cfg = devm_platform_ioremap_resource_byname(pdev, "cfg");
>>>>>> + if (IS_ERR(priv->reg_cfg))
>>>>>> + return PTR_ERR(priv->reg_cfg);
>>>>>> +
>>>>>> + id = of_alias_get_id(dev->of_node, "dc0-constframe");
>>>>>
>>>>> Is it documented? Acked?
>>>>
>>>> Like I replied in patch 06/16, I can add aliases nodes to examples,
>>>> if needed.
>>>>
>>>> No Nak from DT maintainers I'd say, but I hope there will be direct
>>>> Ack(s).
>>>>
>>>
>>> It was not Acked, because there was no documentation added for it.
>>
>> I may add aliases nodes in examples in next version, if no objections.
>
> Example is just example. It is not a documentation. You must explain it
> in the binding, e.g. description.
Ok, I'll explain it in the dt-binding description in next version.
--
Regards,
Liu Ying
