[PATCH 1/1] arm64: dts: mba8mx: Add Ethernet PHY IRQ support

[Alexander Stein <alexander.stein@xxxxxxxxxxxxxxx>]

The interrupt pin of the PHY is connected to the GPIO expander, configure
it accordingly.

Signed-off-by: Alexander Stein <alexander.stein@xxxxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/freescale/mba8mx.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/mba8mx.dtsi b/arch/arm64/boot/dts/freescale/mba8mx.dtsi
index 7b221f43d761e..1ab5cddac0659 100644
--- a/arch/arm64/boot/dts/freescale/mba8mx.dtsi
+++ b/arch/arm64/boot/dts/freescale/mba8mx.dtsi
@@ -204,6 +204,8 @@ ethphy0: ethernet-phy@e {
 			reset-gpios = <&expander2 7 GPIO_ACTIVE_LOW>;
 			reset-assert-us = <500000>;
 			reset-deassert-us = <500>;
+			interrupt-parent = <&expander2>;
+			interrupts = <6 IRQ_TYPE_EDGE_FALLING>;
 
 			leds {
 				#address-cells = <1>;
-- 
2.34.1