New usb glue layer driver support enable dma-coherent. So put dwc3 usb node
under glue layer node and enable dma-coherent.
Signed-off-by: Frank Li <Frank.Li@xxxxxxx>
---
arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 43 ++++++++++++++++----------
1 file changed, 26 insertions(+), 17 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
index 70b8731029c4e..24b937032480f 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
@@ -615,24 +615,33 @@ gpio3: gpio@2320000 {
little-endian;
};
- usb0: usb@3100000 {
- compatible = "fsl,ls1028a-dwc3", "snps,dwc3";
- reg = <0x0 0x3100000 0x0 0x10000>;
- interrupts = <GIC_SPI 80 IRQ_TYPE_LEVEL_HIGH>;
- snps,dis_rxdet_inp3_quirk;
- snps,quirk-frame-length-adjustment = <0x20>;
- snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
- status = "disabled";
- };
+ usb {
+ compatible = "fsl,ls1028a-dwc3";
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+
+ usb0: usb@3100000 {
+ compatible = "snps,dwc3";
+ reg = <0x0 0x3100000 0x0 0x10000>;
+ interrupts = <GIC_SPI 80 IRQ_TYPE_LEVEL_HIGH>;
+ dma-coherent;
+ snps,dis_rxdet_inp3_quirk;
+ snps,quirk-frame-length-adjustment = <0x20>;
+ snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
+ status = "disabled";
+ };
- usb1: usb@3110000 {
- compatible = "fsl,ls1028a-dwc3", "snps,dwc3";
- reg = <0x0 0x3110000 0x0 0x10000>;
- interrupts = <GIC_SPI 81 IRQ_TYPE_LEVEL_HIGH>;
- snps,dis_rxdet_inp3_quirk;
- snps,quirk-frame-length-adjustment = <0x20>;
- snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
- status = "disabled";
+ usb1: usb@3110000 {
+ compatible = "snps,dwc3";
+ reg = <0x0 0x3110000 0x0 0x10000>;
+ interrupts = <GIC_SPI 81 IRQ_TYPE_LEVEL_HIGH>;
+ dma-coherent;
+ snps,dis_rxdet_inp3_quirk;
+ snps,quirk-frame-length-adjustment = <0x20>;
+ snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
+ status = "disabled";
+ };
};
sata: sata@3200000 {
--
2.34.1
