From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> Change the HW model in sm8650-qrd.dts to a one closer to reality - where the WLAN and Bluetooth modules of the WCN7850 are powered by the PMU inside the package. Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/sm8650-qrd.dts | 28 +++++++++------------------- 1 file changed, 9 insertions(+), 19 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/sm8650-qrd.dts b/arch/arm64/boot/dts/qcom/sm8650-qrd.dts index b0d7927b708f..8ca0d28eba9b 100644 --- a/arch/arm64/boot/dts/qcom/sm8650-qrd.dts +++ b/arch/arm64/boot/dts/qcom/sm8650-qrd.dts @@ -208,13 +208,10 @@ wcn7850-pmu { compatible = "qcom,wcn7850-pmu"; pinctrl-names = "default"; - pinctrl-0 = <&wlan_en>; + pinctrl-0 = <&wlan_en>, <&bt_default>; wlan-enable-gpios = <&tlmm 16 GPIO_ACTIVE_HIGH>; - /* - * TODO Add bt-enable-gpios once the Bluetooth driver is - * converted to using the power sequencer. - */ + bt-enable-gpios = <&tlmm 17 GPIO_ACTIVE_HIGH>; vdd-supply = <&vreg_s4i_0p85>; vddio-supply = <&vreg_l15b_1p8>; @@ -1255,22 +1252,15 @@ &uart14 { bluetooth { compatible = "qcom,wcn7850-bt"; - clocks = <&rpmhcc RPMH_RF_CLK1>; - - vddio-supply = <&vreg_l3c_1p2>; - vddaon-supply = <&vreg_l15b_1p8>; - vdddig-supply = <&vreg_s3c_0p9>; - vddrfa0p8-supply = <&vreg_s3c_0p9>; - vddrfa1p2-supply = <&vreg_s1c_1p2>; - vddrfa1p9-supply = <&vreg_s6c_1p8>; + vddrfacmn-supply = <&vreg_pmu_rfa_cmn>; + vddaon-supply = <&vreg_pmu_aon_0p59>; + vddwlcx-supply = <&vreg_pmu_wlcx_0p8>; + vddwlmx-supply = <&vreg_pmu_wlmx_0p85>; + vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>; + vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>; + vddrfa1p8-supply = <&vreg_pmu_rfa_1p8>; max-speed = <3200000>; - - enable-gpios = <&tlmm 17 GPIO_ACTIVE_HIGH>; - swctrl-gpios = <&tlmm 18 GPIO_ACTIVE_HIGH>; - - pinctrl-0 = <&bt_default>; - pinctrl-names = "default"; }; }; -- 2.43.0