On Sat, 29 Jun 2024 16:04:40 -0300 Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx> wrote: > The behavior of an SPI controller data output line (SDO or MOSI or COPI > (Controller Output Peripheral Input) for disambiguation) is usually not > specified when the controller is not clocking out data on SCLK edges. > However, there do exist SPI peripherals that require specific MOSI line > state when data is not being clocked out of the controller. > > Conventional SPI controllers may set the MOSI line on SCLK edges then bring > it low when no data is going out or leave the line the state of the last > transfer bit. More elaborated controllers are capable to set the MOSI idle > state according to different configurable levels and thus are more suitable > for interfacing with demanding peripherals. > > Add SPI mode bits to allow peripherals to request explicit MOSI idle state > when needed. > > When supporting a particular MOSI idle configuration, the data output line > state is expected to remain at the configured level when the controller is > not clocking out data. When a device that needs a specific MOSI idle state > is identified, its driver should request the MOSI idle configuration by > setting the proper SPI mode bit. > > Acked-by: Nuno Sa <nuno.sa@xxxxxxxxxx> > Signed-off-by: Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx> I always like to see some nice ascii art. Very nice documentation. Reviewed-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx> > diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c > index 93f59ebb5b79..c8ba5e490850 100644 > --- a/drivers/spi/spi.c > +++ b/drivers/spi/spi.c > @@ -3950,6 +3956,7 @@ int spi_setup(struct spi_device *spi) > */ > bad_bits = spi->mode & ~(spi->controller->mode_bits | SPI_CS_WORD | > SPI_NO_TX | SPI_NO_RX); > + Trivial grumpy comment. Don't touch white space in unrelated code! > ugly_bits = bad_bits & > (SPI_TX_DUAL | SPI_TX_QUAD | SPI_TX_OCTAL | > SPI_RX_DUAL | SPI_RX_QUAD | SPI_RX_OCTAL);
