On 6/26/2024 7:58 AM, Andrew Halaney wrote: > On Tue, Jun 25, 2024 at 04:49:30PM GMT, Sagar Cheluvegowda wrote: >> When mac link goes down we don't need to mainitain the clocks to operate >> at higher frequencies, as an optimized solution to save power when >> the link goes down we are trying to bring down the clocks to the >> frequencies corresponding to the lowest speed possible. >> >> Signed-off-by: Sagar Cheluvegowda <quic_scheluve@xxxxxxxxxxx> >> --- >> drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++++++ >> 1 file changed, 8 insertions(+) >> >> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c >> index ec7c61ee44d4..f0166f0bc25f 100644 >> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c >> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c >> @@ -996,6 +996,9 @@ static void stmmac_mac_link_down(struct phylink_config *config, >> { >> struct stmmac_priv *priv = netdev_priv(to_net_dev(config->dev)); >> >> + if (priv->plat->fix_mac_speed) >> + priv->plat->fix_mac_speed(priv->plat->bsp_priv, SPEED_10, mode); >> + >> stmmac_mac_set(priv, priv->ioaddr, false); >> priv->eee_active = false; >> priv->tx_lpi_enabled = false; >> @@ -1004,6 +1007,11 @@ static void stmmac_mac_link_down(struct phylink_config *config, >> >> if (priv->dma_cap.fpesel) >> stmmac_fpe_link_state_handle(priv, false); >> + >> + stmmac_set_icc_bw(priv, SPEED_10); >> + >> + if (priv->plat->fix_mac_speed) >> + priv->plat->fix_mac_speed(priv->plat->bsp_priv, SPEED_10, mode); > > > I think you're doing this at the beginning and end of > stmmac_mac_link_down(), is that intentional? > > I realised that bringing down the clock to 10Mbps should be the last operation of the link down process, the reason being if we bring down the clocks first it will deprive essential internal clocks to DMA/MTL modules which are required for Cleanup operations this might cause excessive delays in stopping DMA or flusing MTL queues. >