On 6/27/24 2:13 PM, Alexandre TORGUE wrote:
Hi Marek
Hi,
On 6/23/24 21:15, Marek Vasut wrote:
The efuses on STM32MP13xx can be populated with ethernet MAC address.
Add the nvmem-cells/nvmem-cell-name DT properties to ethernet MAC DT
nodes to describe the placement of both MAC address fields within the
efuses, so the ethernet MAC driver can access the efuses and populate
the correct MAC address into the hardware.
Signed-off-by: Marek Vasut <marex@xxxxxxx>
---
Cc: Alexandre Torgue <alexandre.torgue@xxxxxxxxxxx>
Cc: Christophe Roullier <christophe.roullier@xxxxxxxxxxx>
Cc: Conor Dooley <conor+dt@xxxxxxxxxx>
Cc: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx>
Cc: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
Cc: Rob Herring <robh@xxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: kernel@xxxxxxxxxxxxxxxxxx
Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
Cc: linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
---
arch/arm/boot/dts/st/stm32mp131.dtsi | 2 ++
arch/arm/boot/dts/st/stm32mp133.dtsi | 2 ++
2 files changed, 4 insertions(+)
diff --git a/arch/arm/boot/dts/st/stm32mp131.dtsi
b/arch/arm/boot/dts/st/stm32mp131.dtsi
index f41508195eb51..55f4150524f3c 100644
--- a/arch/arm/boot/dts/st/stm32mp131.dtsi
+++ b/arch/arm/boot/dts/st/stm32mp131.dtsi
@@ -1528,6 +1528,8 @@ ethernet1: ethernet@5800a000 {
<&rcc ETH1RX>,
<&rcc ETH1STP>,
<&rcc ETH1CK_K>;
+ nvmem-cell-names = "mac-address";
+ nvmem-cells = <ðernet_mac1_address>;
It should not be defined in soc dtsi file but rather in board file. OTP
are provisioned by the end customer not by ST. If you order a SoC to ST
it will not be provisioned OTP MAC addr will be set to 0.
That's right, but at least the MAC address will be in the same locations
in OTP, and if the MAC from OTP is all zeroes, than it wouldn't be
considered a valid MAC address.
In any case, I'll do board specific V2 shortly.
