On 6/27/2024 12:47 AM, Dmitry Baryshkov wrote:
On Tue, Jun 25, 2024 at 11:03:30AM GMT, Gokul Sriram P wrote:
On 6/22/2024 2:38 AM, Dmitry Baryshkov wrote:
On Fri, Jun 21, 2024 at 05:16:52PM GMT, Gokul Sriram Palanisamy wrote:
PRNG clock is needed by the secure PIL, support for the same
is added in subsequent patches.
Which 'same'?
What is 'secure PIL'?
will elaborate in the updated version.
To answer your question, secure PIL is signed PIL image which only
TrustZone can authenticate and load.
Fine. So, the current driver can not load WCSS firmware on IPQ8074, is
that correct? Or was there some kind of firmware interface change? The
driver was added in 2018, so I can only hope that at that point it
worked. Could you please explain, what happened?
The existing wcss driver can load unsigned PIL images without the
involvement of TrustZone. That works even now.
With the current change, we are trying to add signed PIL as an option
based on "wcss->need_mem_protection" if set. For signed PIL alone, we
send a PAS request to TrustZone to authenticate and load.
I also just noticed that Bjorn had suggested to submit a new driver for
the PAS based IPQ WCSS instead of overloading this driver. Will also
address that and post a new driver in updated revision.
Regards,
Gokul
Signed-off-by: Nikhil Prakash V <quic_nprakash@xxxxxxxxxxx>
Signed-off-by: Sricharan R <quic_srichara@xxxxxxxxxxx>
Signed-off-by: Gokul Sriram Palanisamy <quic_gokulsri@xxxxxxxxxxx>
---
drivers/remoteproc/qcom_q6v5_wcss.c | 65 +++++++++++++++++++++--------
1 file changed, 47 insertions(+), 18 deletions(-)
