Re: [PATCH v6 03/16] dt-bindings: mfd: mediatek: Add codec property for MT6357 PMIC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 25/06/2024 11:23, Alexandre Mergnat wrote:
> 
> 
> On 21/06/2024 17:00, Krzysztof Kozlowski wrote:
>> On 19/06/2024 16:46, Alexandre Mergnat wrote:
>>> Add the audio codec sub-device. This sub-device is used to set the
>>> optional voltage values according to the hardware.
>>> The properties are:
>>>    - Setup of microphone bias voltage.
>>>    - Setup of the speaker pin pull-down.
>>>
>>> Also, add the audio power supply property which is dedicated for
>>> the audio codec sub-device.
>>>
>>> Signed-off-by: Alexandre Mergnat<amergnat@xxxxxxxxxxxx>
>>> ---
>>>   .../devicetree/bindings/mfd/mediatek,mt6357.yaml   | 33 ++++++++++++++++++++++
>>>   1 file changed, 33 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml b/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml
>>> index 37423c2e0fdf..d95307393e75 100644
>>> --- a/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml
>>> +++ b/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml
>>> @@ -37,6 +37,32 @@ properties:
>>>     "#interrupt-cells":
>>>       const: 2
>>>   
>>> +  vaud28-supply:
>>> +    description: 2.8 volt supply phandle for the audio codec
>>> +
>>> +  audio-codec:
>>> +    type: object
>> Still not much improved. You do not have any resources there, so these
>> should go to the parent node.
> 
> Hi Krzysztof,
> 
> vaud28-supply seems to be a mistake that I forward port.
> In the V4, AFAII, your feedback [1] suggested me to move the vaud28-supply from the "audio-codec" 
> sub-node to the parent node, which for me is the "pmic" (mfd), because the property is considered as 
> power-supply.
> 
>      pwrap {
>          pmic {
>              ...
>              audio-codec {
>                  ...
> 
> Hardware side, vaud28-supply is the output of PMIC-regulator subsystem, and AVDD28 is the input of 
> PMIC-audio-codec subsystem. Then:
> - The property name is wrong and must be change to AVDD28, which is a consumer (power input), not a 
> power-supply. => description: 2.8 volt power input for microphones (AU_VIN0, AU_VIN1, AU_VIN2)
> - IMHO, move this property to the next parent (pwrap) isn't consistent. It should be moved back to 
> Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml (Done in the V4) into audio-codec 
> substystem, beside mediatek,micbias0-microvolt

I don't understand why do we talk again about supply. My comment was not
under the supply.

Best regards,
Krzysztof





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux