Add Ethernet support for STM32MP25.
STM32MP25 is STM32 SOC with 2 GMACs instances.
GMAC IP version is SNPS 5.3x.
GMAC IP configure with 2 RX and 4 TX queue.
DMA HW capability register supported
RX Checksum Offload Engine supported
TX Checksum insertion supported
Wake-Up On Lan supported
TSO supported
Signed-off-by: Christophe Roullier <christophe.roullier@xxxxxxxxxxx>
Reviewed-by: Simon Horman <horms@xxxxxxxxxx>
---
.../net/ethernet/stmicro/stmmac/dwmac-stm32.c | 80 ++++++++++++++++++-
1 file changed, 77 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
index b2db0e26c4e4..23cf0a5b047f 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
@@ -53,7 +53,18 @@
#define SYSCFG_MCU_ETH_SEL_MII 0
#define SYSCFG_MCU_ETH_SEL_RMII 1
-/* STM32MP1 register definitions
+/* STM32MP2 register definitions */
+#define SYSCFG_MP2_ETH_MASK GENMASK(31, 0)
+
+#define SYSCFG_ETHCR_ETH_PTP_CLK_SEL BIT(2)
+#define SYSCFG_ETHCR_ETH_CLK_SEL BIT(1)
+#define SYSCFG_ETHCR_ETH_REF_CLK_SEL BIT(0)
+
+#define SYSCFG_ETHCR_ETH_SEL_MII 0
+#define SYSCFG_ETHCR_ETH_SEL_RGMII BIT(4)
+#define SYSCFG_ETHCR_ETH_SEL_RMII BIT(6)
+
+/* STM32MPx register definitions
*
* Below table summarizes the clock requirement and clock sources for
* supported phy interface modes.
@@ -104,7 +115,7 @@ struct stm32_ops {
int (*parse_data)(struct stm32_dwmac *dwmac,
struct device *dev);
bool clk_rx_enable_in_suspend;
- bool is_mp13;
+ bool is_mp13, is_mp2;
u32 syscfg_clr_off;
};
@@ -277,8 +288,55 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
dwmac->mode_mask, val);
}
+static int stm32mp2_configure_syscfg(struct plat_stmmacenet_data *plat_dat)
+{
+ struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
+ u32 reg = dwmac->mode_reg;
+ int val = 0;
+
+ switch (plat_dat->mac_interface) {
+ case PHY_INTERFACE_MODE_MII:
+ /* ETH_REF_CLK_SEL bit in SYSCFG register is not applicable in MII mode */
+ break;
+ case PHY_INTERFACE_MODE_RMII:
+ val = SYSCFG_ETHCR_ETH_SEL_RMII;
+ if (dwmac->enable_eth_ck) {
+ /* Internal clock ETH_CLK of 50MHz from RCC is used */
+ val |= SYSCFG_ETHCR_ETH_REF_CLK_SEL;
+ }
+ break;
+ case PHY_INTERFACE_MODE_RGMII:
+ case PHY_INTERFACE_MODE_RGMII_ID:
+ case PHY_INTERFACE_MODE_RGMII_RXID:
+ case PHY_INTERFACE_MODE_RGMII_TXID:
+ val = SYSCFG_ETHCR_ETH_SEL_RGMII;
+ fallthrough;
+ case PHY_INTERFACE_MODE_GMII:
+ if (dwmac->enable_eth_ck) {
+ /* Internal clock ETH_CLK of 125MHz from RCC is used */
+ val |= SYSCFG_ETHCR_ETH_CLK_SEL;
+ }
+ break;
+ default:
+ dev_err(dwmac->dev, "Mode %s not supported",
+ phy_modes(plat_dat->mac_interface));
+ /* Do not manage others interfaces */
+ return -EINVAL;
+ }
+
+ dev_dbg(dwmac->dev, "Mode %s", phy_modes(plat_dat->mac_interface));
+
+ /* Select PTP (IEEE1588) clock selection from RCC (ck_ker_ethxptp) */
+ val |= SYSCFG_ETHCR_ETH_PTP_CLK_SEL;
+
+ /* Update ETHCR (set register) */
+ return regmap_update_bits(dwmac->regmap, reg,
+ SYSCFG_MP2_ETH_MASK, val);
+}
+
static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
{
+ struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
int ret;
ret = stm32mp1_select_ethck_external(plat_dat);
@@ -289,7 +347,10 @@ static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
if (ret)
return ret;
- return stm32mp1_configure_pmcr(plat_dat);
+ if (!dwmac->ops->is_mp2)
+ return stm32mp1_configure_pmcr(plat_dat);
+ else
+ return stm32mp2_configure_syscfg(plat_dat);
}
static int stm32mcu_set_mode(struct plat_stmmacenet_data *plat_dat)
@@ -365,6 +426,9 @@ static int stm32_dwmac_parse_data(struct stm32_dwmac *dwmac,
return err;
}
+ if (dwmac->ops->is_mp2)
+ return 0;
+
dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
err = of_property_read_u32_index(np, "st,syscon", 2, &dwmac->mode_mask);
if (err) {
@@ -586,10 +650,20 @@ static struct stm32_ops stm32mp13_dwmac_data = {
.clk_rx_enable_in_suspend = true
};
+static struct stm32_ops stm32mp25_dwmac_data = {
+ .set_mode = stm32mp1_set_mode,
+ .suspend = stm32mp1_suspend,
+ .resume = stm32mp1_resume,
+ .parse_data = stm32mp1_parse_data,
+ .is_mp2 = true,
+ .clk_rx_enable_in_suspend = true
+};
+
static const struct of_device_id stm32_dwmac_match[] = {
{ .compatible = "st,stm32-dwmac", .data = &stm32mcu_dwmac_data},
{ .compatible = "st,stm32mp1-dwmac", .data = &stm32mp1_dwmac_data},
{ .compatible = "st,stm32mp13-dwmac", .data = &stm32mp13_dwmac_data},
+ { .compatible = "st,stm32mp25-dwmac", .data = &stm32mp25_dwmac_data},
{ }
};
MODULE_DEVICE_TABLE(of, stm32_dwmac_match);
--
2.25.1
