On 03/04/2015 10:38 AM, Ivan T. Ivanov wrote: > > Hi Stan, > > It looks good now, except it doesn't apply and two small issues below: > <snip> > >> + >> + /* set DMA parameters */ >> + rx_conf->direction = DMA_DEV_TO_MEM; >> + rx_conf->device_fc = 1; > > Strictly speeching this is a bool not int. sure will correct. >> >> + ret = spi_qup_init_dma(master, res->start); >> + if (ret == -EPROBE_DEFER) >> + goto error; >> + else if (!ret) >> + master->can_dma = spi_qup_can_dma; >> + >> /* set v1 flag if device is version 1 */ >> if (of_device_is_compatible(dev->of_node, "qcom,spi-qup-v1.1.1")) >> controller->qup_v1 = 1; > > It is not visible from this patch, but in case of error reseting > SPI controller (QUP_STATE_RESET), exit error path should be > 'error_dma' and not 'error' label. my fault, will correct. regards, Stan -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
