On Mon, May 27, 2024 at 02:55:02PM +0200, Bartosz Golaszewski wrote: > From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> > > Parse the "memory-region" property and - if present - use it to assign > the dedicated reserved memory to the underlying DMA callbacks which will > then allocate memory for the SCM calls from it. > > Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> Reviewed-by: Elliot Berman <quic_eberman@xxxxxxxxxxx> > --- > drivers/firmware/qcom/qcom_scm.c | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/drivers/firmware/qcom/qcom_scm.c b/drivers/firmware/qcom/qcom_scm.c > index 94c34cde8179..c82957727650 100644 > --- a/drivers/firmware/qcom/qcom_scm.c > +++ b/drivers/firmware/qcom/qcom_scm.c > @@ -23,6 +23,7 @@ > #include <linux/of_address.h> > #include <linux/of_irq.h> > #include <linux/of_platform.h> > +#include <linux/of_reserved_mem.h> > #include <linux/platform_device.h> > #include <linux/reset-controller.h> > #include <linux/sizes.h> > @@ -1942,6 +1943,11 @@ static int qcom_scm_probe(struct platform_device *pdev) > if (of_property_read_bool(pdev->dev.of_node, "qcom,sdi-enabled")) > qcom_scm_disable_sdi(); > > + ret = of_reserved_mem_device_init(__scm->dev); > + if (ret && ret != -ENODEV) > + return dev_err_probe(__scm->dev, ret, > + "Failed to setup the reserved memory region for TZ mem\n"); > + > ret = qcom_tzmem_enable(__scm->dev); > if (ret) > return dev_err_probe(__scm->dev, ret, > > -- > 2.43.0 >
