Generalize set_led_current function as the implementation is the same for
most of the lp55xx based LED driver.
Suggested-by: Lee Jones <lee@xxxxxxxxxx>
Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx>
---
drivers/leds/leds-lp5521.c | 12 ++++--------
drivers/leds/leds-lp5523.c | 12 ++++--------
drivers/leds/leds-lp55xx-common.c | 11 +++++++++++
drivers/leds/leds-lp55xx-common.h | 3 +++
drivers/leds/leds-lp8501.c | 12 ++++--------
5 files changed, 26 insertions(+), 24 deletions(-)
diff --git a/drivers/leds/leds-lp5521.c b/drivers/leds/leds-lp5521.c
index dd7e996f22f9..a1a3bf0ff703 100644
--- a/drivers/leds/leds-lp5521.c
+++ b/drivers/leds/leds-lp5521.c
@@ -108,13 +108,6 @@ static inline void lp5521_wait_enable_done(void)
usleep_range(500, 600);
}
-static void lp5521_set_led_current(struct lp55xx_led *led, u8 led_current)
-{
- led->led_current = led_current;
- lp55xx_write(led->chip, LP5521_REG_LED_CURRENT_BASE + led->chan_nr,
- led_current);
-}
-
static void lp5521_stop_engine(struct lp55xx_chip *chip)
{
enum lp55xx_engine_index idx = chip->engine_idx;
@@ -359,11 +352,14 @@ static struct lp55xx_device_config lp5521_cfg = {
.reg_led_pwm_base = {
.addr = LP5521_REG_LED_PWM_BASE,
},
+ .reg_led_current_base = {
+ .addr = LP5521_REG_LED_CURRENT_BASE,
+ },
.max_channel = LP5521_MAX_LEDS,
.post_init_device = lp5521_post_init_device,
.brightness_fn = lp55xx_led_brightness,
.multicolor_brightness_fn = lp55xx_multicolor_brightness,
- .set_led_current = lp5521_set_led_current,
+ .set_led_current = lp55xx_set_led_current,
.firmware_cb = lp55xx_firmware_loaded_cb,
.run_engine = lp5521_run_engine,
.dev_attr_group = &lp5521_group,
diff --git a/drivers/leds/leds-lp5523.c b/drivers/leds/leds-lp5523.c
index bfa0c4431ede..3030a4495808 100644
--- a/drivers/leds/leds-lp5523.c
+++ b/drivers/leds/leds-lp5523.c
@@ -122,13 +122,6 @@ static inline void lp5523_wait_opmode_done(void)
usleep_range(1000, 2000);
}
-static void lp5523_set_led_current(struct lp55xx_led *led, u8 led_current)
-{
- led->led_current = led_current;
- lp55xx_write(led->chip, LP5523_REG_LED_CURRENT_BASE + led->chan_nr,
- led_current);
-}
-
static int lp5523_post_init_device(struct lp55xx_chip *chip)
{
int ret;
@@ -731,12 +724,15 @@ static struct lp55xx_device_config lp5523_cfg = {
.reg_led_pwm_base = {
.addr = LP5523_REG_LED_PWM_BASE,
},
+ .reg_led_current_base = {
+ .addr = LP5523_REG_LED_CURRENT_BASE,
+ },
.pages_per_engine = LP5523_PAGES_PER_ENGINE,
.max_channel = LP5523_MAX_LEDS,
.post_init_device = lp5523_post_init_device,
.brightness_fn = lp55xx_led_brightness,
.multicolor_brightness_fn = lp55xx_multicolor_brightness,
- .set_led_current = lp5523_set_led_current,
+ .set_led_current = lp55xx_set_led_current,
.firmware_cb = lp55xx_firmware_loaded_cb,
.run_engine = lp5523_run_engine,
.dev_attr_group = &lp5523_group,
diff --git a/drivers/leds/leds-lp55xx-common.c b/drivers/leds/leds-lp55xx-common.c
index 27008b6a4757..d17538ebfcf9 100644
--- a/drivers/leds/leds-lp55xx-common.c
+++ b/drivers/leds/leds-lp55xx-common.c
@@ -277,6 +277,17 @@ int lp55xx_multicolor_brightness(struct lp55xx_led *led)
}
EXPORT_SYMBOL_GPL(lp55xx_multicolor_brightness);
+void lp55xx_set_led_current(struct lp55xx_led *led, u8 led_current)
+{
+ struct lp55xx_chip *chip = led->chip;
+ const struct lp55xx_device_config *cfg = chip->cfg;
+
+ led->led_current = led_current;
+ lp55xx_write(led->chip, cfg->reg_led_current_base.addr + led->chan_nr,
+ led_current);
+}
+EXPORT_SYMBOL_GPL(lp55xx_set_led_current);
+
static void lp55xx_reset_device(struct lp55xx_chip *chip)
{
const struct lp55xx_device_config *cfg = chip->cfg;
diff --git a/drivers/leds/leds-lp55xx-common.h b/drivers/leds/leds-lp55xx-common.h
index 021dd17bc5d7..e638049d9297 100644
--- a/drivers/leds/leds-lp55xx-common.h
+++ b/drivers/leds/leds-lp55xx-common.h
@@ -101,6 +101,7 @@ struct lp55xx_reg {
* @enable : Chip specific enable command
* @prog_mem_base : Chip specific base reg address for chip SMEM programming
* @reg_led_pwm_base : Chip specific base reg address for LED PWM conf
+ * @reg_led_current_base : Chip specific base reg address for LED current conf
* @pages_per_engine : Assigned pages for each engine
* (if not set chip doesn't support pages)
* @max_channel : Maximum number of channels
@@ -120,6 +121,7 @@ struct lp55xx_device_config {
const struct lp55xx_reg enable;
const struct lp55xx_reg prog_mem_base;
const struct lp55xx_reg reg_led_pwm_base;
+ const struct lp55xx_reg reg_led_current_base;
const int pages_per_engine;
const int max_channel;
@@ -217,6 +219,7 @@ extern int lp55xx_update_program_memory(struct lp55xx_chip *chip,
extern void lp55xx_firmware_loaded_cb(struct lp55xx_chip *chip);
extern int lp55xx_led_brightness(struct lp55xx_led *led);
extern int lp55xx_multicolor_brightness(struct lp55xx_led *led);
+extern void lp55xx_set_led_current(struct lp55xx_led *led, u8 led_current);
/* common probe/remove function */
extern int lp55xx_probe(struct i2c_client *client);
diff --git a/drivers/leds/leds-lp8501.c b/drivers/leds/leds-lp8501.c
index 8f1fd9525e9a..d924572e4533 100644
--- a/drivers/leds/leds-lp8501.c
+++ b/drivers/leds/leds-lp8501.c
@@ -84,13 +84,6 @@ static inline void lp8501_wait_opmode_done(void)
usleep_range(1000, 2000);
}
-static void lp8501_set_led_current(struct lp55xx_led *led, u8 led_current)
-{
- led->led_current = led_current;
- lp55xx_write(led->chip, LP8501_REG_LED_CURRENT_BASE + led->chan_nr,
- led_current);
-}
-
static int lp8501_post_init_device(struct lp55xx_chip *chip)
{
int ret;
@@ -163,11 +156,14 @@ static struct lp55xx_device_config lp8501_cfg = {
.reg_led_pwm_base = {
.addr = LP8501_REG_LED_PWM_BASE,
},
+ .reg_led_current_base = {
+ .addr = LP8501_REG_LED_CURRENT_BASE,
+ },
.pages_per_engine = LP8501_PAGES_PER_ENGINE,
.max_channel = LP8501_MAX_LEDS,
.post_init_device = lp8501_post_init_device,
.brightness_fn = lp55xx_led_brightness,
- .set_led_current = lp8501_set_led_current,
+ .set_led_current = lp55xx_set_led_current,
.firmware_cb = lp55xx_firmware_loaded_cb,
.run_engine = lp8501_run_engine,
};
--
2.45.1
